User manual ZANKER ZV4000

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. ried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. Always insist on genuine spare parts. General safety · Dishwasher detergents can cause chemical burns to eyes, mouth and throat. [. . . ] Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. The salt container will require topping up periodically. The salt cap has a refill indicator window in the centre in which a green float is clearly visible when there is salt inside the container and almost disappears when the salt has finished. 9 Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close the lid and press until it indicated by "max" locks. CAUTION!Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid detergent). This would damage the appliance. Top up the rinse aid indicator (B) becomes clear Adjusting the dosage of rinse aid Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades. 10 Open the lid. Set the dosage level. (The Close the lid and press undose is factory set in po- til it locks. sition 4). Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. Incorrect repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing comwater. move filters B and C. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. Cleaning the spray arms NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove them with a cocktail stick. 15 External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). 3. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run the wash programme for heavy soiled dishes using detergent but without dishes. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge hoses. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. Prolonged periods of nonoperation If you are not using the machine for any prolonged period of time you are advised to: 1. [. . . ] Therefore do not immerse the water inlet hose or the safety valve in water. Take care when installing the water inlet hose . Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve. If the water inlet hose or the safety valve is damaged, remove the mains plug immediately. A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre. Drain hose Connect drain hose to the The waste connection sink. [. . . ]