User manual ZANUSSI ADVANTAGE55

[. . . ] WASHING MACHINE PRALKA AUTOMATYCZNA AUTOMATICKÁ PRACKA AUTOMATICKÁ PRÁCKA AUTOMATA MOSÓGÉP 35. 292. 783/0 USER MANUAL INSTRUKCJA OBSLUGI NÁVOD NA OBSLUHU NÁVOD K OBSLUZE HASZNÁLATI ÚTMUTATÓ GB PL CZ SK H Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. The symbols you will see on some paragraphs of this booklet have the following meaning: The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. [. . . ] Selecting any program can be run through with cold water. This will ensure a saving in electricity consumption. 2. "NO SPINNING" button Pressing this button before starting the "intense" washing programmes all spinnings will be excluded. The other steps of the program remain unchanged. 3. button Pressing this button before starting the intense program there will be one rinse less which leads to energy and water saving. 6. Program selector To select the required programme turn the control clockwise to the required program. If at any chance you pass by the required programme NEVER TURN THE CONTROL ANTICLOCKWISE just continue clockwise until the required programme is reached again. 4. On/off lamp It lights when the appliance is operating. 10 Washing hints Sorting the laundry Follow the wash code symbols on each garment label and the manufacturer's washing instructions. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. 11 Maximum loads Recommended loads are indicated in the programme charts. General rules: Cotton, linen: drum full but not too tightly packed; Synthetics: drum no more than half full; Delicate fabrics and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size. ENGLISH Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load, ­ the laundry is lightly soiled, ­ large amounts of foam form during washing. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc. ), the colour, washing temperature and degree of soiling. [. . . ] · The programme selector is not positioned correctly or the programme selector knob has not been pulled out. · The machine does not fill: · The water tap is closed. · The inlet hose is squashed or kinked. · The filter in the inlet hose is blocked. · The door is not properly closed. · The machine fills then empties immediately: · The machine does not empty and/or does not spin: · The end of the drain hose is too low. [. . . ]