User manual ZANUSSI BMN494ES

[. . . ] Otherwise, contact your dealer before proceeding with the installation. Some parts of the appliance are covered by a shockproof plastic film. This appliance is meant to operate with a singlephased connection to 230V electrical supply. An eventual 400V poliphasic connection without earth wire will destroy the oven and the hob, if fitted. The manufacturer disclaims any responsability should all the safety measures not be carried out. Service Under no circumstances should you attempt to repair the appliance yourself. [. . . ] When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the oven function and the thermostat control knob to zero. To switch off the acoustic alarm, press any button. NOTE: when doing this operation, the oven will be operated again, therefore, remember to turn the oven function and the thermostat control knob to zero at the end of the cooking time. Press button repeatedly to select the Cooking Duration function. The relevant pilot lamp will flash and the display will show the remaining cooking time. Press button until the display shows 0:00. After 5 seconds the pilot lamp will go out and the display will revert to the time of day. 7 Thanks to this function, you can set the oven to switch off automatically when a programmed end of cooking time is over. Place food in the oven, select a cooking function and adjust the cooking temperature. Press button repeatedly to select the End of cooking function. The relevant pilot lamp will start flashing. The relevant pilot lamp will flash and the display will show the remaining time. Press button until the display shows 0:00. After 5 seconds the pilot lamp will go out and the display will revert to the time of day. How to switch off the display 1. Press two or three programmer push buttons simoultaneously and keep them pressed for about 5 seconds. To switch on the display, press any button. The display can be switched off only if no other functions have been set. 8 Using the Oven Always cook with the oven door closed Conventional cooking Turn the oven function control knob to the relevant symbol ( ) and set the thermostat knob on the required temperature. If you need more heat from the top or the bottom of the oven, turn the oven function control knob to (top heating element only) or (bottom heating element only). A short oven pre-heating (about 10 minutes) is recommeded when cooking cakes or baking. Once the cooking has been started, keep the oven door closed during all the cooking time, and check the cooking results through the oven door glass. Thermal grilling Turn the oven function control knob to the relevant symbol ( ) and set the thermostat knob on the required temperature. When using this cooking function, select a maximum temperature of 200°C and do not exceed 1 hour of operation. The full grill element and the oven fan operate alternately, circulating hot air around the food. [. . . ] uTurn the thermostat knob on a temperature or uTurn the oven function control knob on a function. uTurn the oven function control knob on a function or uBuy a new oven light bulb, asking for it to your local Service Centre and replace it by following the instruction provided in this booklet. uRefer to the contents of this booklet, especially to the chapter "Using the oven". uLeave dishes inside the oven no longer than 15-20 minutes after the cooking is completed. n The oven temperature light does not come on n The oven light does not come on n It takes too much time to finish the dishes, or they are cooked too fast. [. . . ]