User manual ZANUSSI DCS383 W

[. . . ] It must not at any point be higher up than 75 cm over the surface which the dishwasher is standing on. If it runs higher, operation of the dishwasher might be impaired. Don't forget that the water will come out with some force, so position the pipe so that the force of the water will not push the hose out of the sink, use the elbow supplied which should be fitted over the pipe to support it. The discharge hose must not at any point rise higher than the top of the dishwasher. [. . . ] Make sure that the filter is always clean. Lift it out and rinse it under running water whenever necessary. Fine filter 4 It is just as important to keep this filter clean. A dirty or clogged filter will impair washing efficiency. The fine filter can easily be lifted out for cleaning when you have removed the coarse filter. Detergent dispenser 5 Only use detergents specially designed for dishwashers. For a normal load pour about 1-2 tablespoons of detergent into the detergent dispenser. Spray arm 2 It is important to keep all the holes in the spray arm clear. If the spray arm becomes blocked this will affect washing efficiency. If the spray arm needs cleaning, unscrew the nut clockwise (left-hand thread) and lift off the spray arm. Clear the holes and shake out any food particles. -4- The control panel and programmes All figures are nominal and vary for example due to temperature variations on the inlet water. The figures apply to washing up 5 IEC-settings. 1 2 3 5 4 1 On/Off-button Press the button in order to start the required programme. Door lock Press the handle down and open the door. Avoid opening the door while the machine is running. If the door is opened and is put standing ajar after a completed programme the dishes will dry faster. 2 3 4 Temperature selector Press the button in for 55°C. Temperature selector Press the button in for 65°C. Programmes Prerinse is used if you want to wait until you have a full load. This cycle rinses the load and keeps it moist, making the main wash easier later on. It does not matter which temperature you select. Intensive for loads which have heavily dried-on food remnants and for those which are heavily soiled. Normal for normal soiled loads, which do not need any rinse off. Rinse for warm or hot rinsing for dishes (65°C) or glasses (55°C). Plate warming is used for warming dinner plates etc. prior to serving a meal. Programme selector Turn the programme selector clockwise to the programme required and press in the On/Off button. During the water heating process, the timer is standing still. To isolate the dishwasher from the mains completely, unplug it from the wall socket. 5 Indicator lamp While the programme is in progress, the operating lamp is lit and it goes out when the programme is ready. -5- How to load the dishwasher The illustration shows the machine loaded with five standard place settings. Your own dishes are not likely to be identical to this load, but if you follow the advice below we are sure you will be pleased with the results. q q Always place glasses, cups and bowls upside down. Incline deep dishes (soup plates etc. ) so that the water can run off when drying. [. . . ] Select a wash programme, start the machine and let the programme run for a short time. 2 Building-in If you want to build the dishwasher into your kitchen furniture, it is important to use our approved build-in kit. This comes with the correct instructions needed to observe all the relevant regulations. You can obtain the build-in kit from the same place where you bought the dishwasher. Identification of materials All materials used in packaging this machine are environmentally-friendly. The various plastics used are identified and can be recycled: · PE stands for polyethylene, which is used for the bag around the machine and the bag in which these instructions were supplied. [. . . ]