User manual ZANUSSI DF50/30A

[. . . ] Ensure that you understand them all before installing or using this appliance. If you are unsure about any of the meanings or these warnings contact the Customer Care Department. Prior to installation Check the appliance for transport damage. Under no circumstances should a damaged appliance be installed. In the event of damage please contact your retailer. [. . . ] (See Hints and Tips) Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or frost/freezer burns. Thawing Deep frozen or frozen food, prior to being used, can be thawed in the fridge or at room temperature, depending on the time available. Small food items may even be cooked from frozen, in this case cooking will take longer. Any frozen food which is allowed to thaw accidentally should either be eaten as soon as possible, or thrown away. Alternatively, if the food is uncooked and has not been completely defrosted it can be cooked and then refrozen. Defrosted cooked food must never be refrozen. To Make Ice Cubes 1. Fill the ice cube tray ¾ full with cold water, place in the freezing compartment and leave to freeze. To remove the cubes twist the tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment by using pointed or sharp edged objects. Frozen Food Storage When first starting the freezer or if the freezer has been out of use for some time, we advise you to run your appliance for at least 2 hours before storing frozen food. Do not exceed the storage period indicated by the manufacturer. Do not open the door frequently or leave it open longer than is necessary. Important Do not put carbonated liquids in the freezer. Return the thermostat control knob to a medium setting. Important A temperature rise of the frozen food packs during defrosting may shorten their safe storage life. Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair. How to change the bulb Should the light fail to work you can change it as below: Disconnect the appliance from the electricity supply. Unscrew the screw holding the cover (1), press the rear hook (2) and at the same time slide the cover in the direction indicated by arrow (3). (Bulb type: 230-240 V, 15 W, E 14 thread). After changing the bulb replace the cover, snap it in place, screw back the screw and reconnect the appliance to the mains supply. 12 Something N ot Working If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre. Symptom Possible Cause No power to the appliance No power at the socket. Thermostat control knob is set at , , 0". The temperature in the The appliance is located in an unsuitable position. fridge or freezer is too high The thermostat control knob is set too low. Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. [. . . ] Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. The doors can be aligned by adjusting the middle hinge. The middle hinge can be adjusted horizontally, with the help of a tool, after having slackened the two screws. [. . . ]