User manual ZANUSSI DW900-A

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q q Do not sit or stand on the open door. Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] Finish Powder recommended for every day use. Finish Liquid Gel ideal for every day use. As the gel is extra gentle it is recommended for fine both china. If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). Add the detergent according to the recommendations in the programme chart. As all detergents are not the same, you should also consult the instructions on the packet. If the programme has a prewash add the required detergent over the lid of the dispenser. If using detergent in tablets proceed as follows: 1. For all programmes; place 1 tablet inside the detergent dispenser. For all programmes with prewash; place a portion of a further tablet on the lid of the detergent dispenser. Insufficient quantities of detergent will produce poor washing results, whereas an excessive amount of detergent will not improve washing results and is also wasteful. Once cleaned, refit the filters by pressing them down until they click into place. MA13 MA08 Cleaning the large filter (Once a month) Clean the large filter (A) on both sides under running water, using a brush. To take it out, remove the spray arm by pressing the two tongues (E), turn the ring (F) anticlockwise and then slide the whole part out. Refit the filter following the above instructions in reverse order. E A F MA01 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 14 MAN06en External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. [. . . ] The locknut must be correctly fitted to avoid water leaks. Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. 20 COL08en Water outlet hose connection min 4 cm min 30 cm max 100 cm COL09en The end of the drain hose can be connected in the following ways: 1. [. . . ]