User manual ZANUSSI ER6436U

[. . . ] I N F O INSTRUCTION BOOKLET REFRIGERATOR ER 6436 U 2222682-51 CONTENTS Instructions for the user Important Safety Instructions Description of the Appliance Operation Before use Setting the temperature Fresh food refrigeration The door shelves Normal Operating Sounds Instructions for the installer 3 4 4 4 4 4 5 5 Technical specifications Installation Positioning 13 13 13 Electrical Connection Building-in Instructions Door Reversal Building the appliance in under a worktop Fitting the plinth 14 15 15 17 19 Health and safety guidelines Defrosting Maintenance and Cleaning Internal cleaning External cleaning Periodic cleaning Changing the light bulb When the appliance is not use 6 6 7 7 7 7 7 7 Something not Working?Service and Spare Parts Customer Care Departements Guarantee conditions Electrolux Service Force 8 9 9 10 11 2 IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. If you are unsure about any of the meanings or these warnings contact the Customer Care Departement. Prior to Installation s During Use s Check the appliance for transport damage. [. . . ] Take care not to let the meat juices drip onto other food. If the meat does drip, remove everything and clean thoroughly. Remove suspect food from your refrigerator and clean (Refer to "Maintenance and Cleaning"). s s Never allow spillages to dry and harden. Store eggs in the egg rack provided in the refrigerator door. Regularly check the refrigerator door seal to ensure that it is clean and free from debris. Always wash your hands with soapy water and dry them with a clean towel before handling food. Keep work surfaces clean and avoid cross contamination by not using the same work surface or knife, without washing them thoroughly in between. s s s s s s s s s DEFROSTING The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing and drip ping onto the food in the fridge, periodically clean the water discharge hole (F) situated under the salad drawers. Use the special cleaner provided (P) which you will find already inserted into the discharge hole P F S. I. 011 6 MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Changing the light bulb Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: 1. Unscrew the light cover and then pull it outward by pressing as shown in the figure. Unscrew the bulb and replace it with a new 15 watt bulb (available from your nearest Electrolux Service Force centre). Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES, TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG SMELL. Clean the drain hole of the water trough at regular intervals and make sure that the drain hole is never obstructed, so that the defrost water may flow freely. D411 2. Replace the light cover by sliding it into its original position and replacing the screw. External cleaning Wash the outer cabinet door with warm soapy water. Important Do not use abrasive products. When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. Periodic cleaning The appliance is equipped with a ventilation grid. Keep clean to guarantee good ventilation and good working order of the appliance. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. The structure of the appliance permits to clean the rear zone close to the wall, using a vacuum cleaner. Remove the plinth (1), then the ventilation grid (2); 2. Carefully pull the air deflector out (3), checking that there is no water left from the defrosting. S. I. 013 3 2 1 7 SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. [. . . ] The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home. 87/308 of 2. 6. 87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directive: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent amendments. [. . . ]