User manual ZANUSSI FA5423

[. . . ] WASHING MACHINE FA 5423 60°-90° B BLANCOS 40°-60° B COLORES RESISTENTES 30°-40° C COLORES DELICADOS 60°-90° A BLANCOS CON PRELAV. ACLARADOS D SUAVIZANTES F CENTRIFUGADO G SINTETICOS 30°-60° J DELICADOS 30°-40° K LANA 30°-40° L SINTETICOS CON PRELAV. 30°-60° H ACLARADOS M SUAVIZANTES N DESCARGA P P BA N M C LK 30° D 90° 80 ° 35. 292. 909/0 INSTRUCTION BOOKLET JH G F 70° 60° 50° 40 ° Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged. [. . . ] "NO SPINNING" button Pressing this button before starting the "intense" washing programmes all spinnings will be excluded. The other steps of the program remain unchanged. To select the required program turn the control clockwise until the marker on the top coincides with the letter of the required program (reference mark on the control panel). Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. 11 Maximum loads Recommended loads are indicated in the programme charts. General rules: Cotton, linen: drum full but not too tightly packed; Synthetics: drum no more than half full; Delicate fabrics and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. [. . . ] · The door is not properly closed. · The machine fills then empties immediately: · The machine does not empty and/or does not spin: · The end of the drain hose is too low. Refer to relevant paragraph in "water drainage" section. · The drain hose is squashed or kinked. · The laundry is not evenly distributed in the drum. [. . . ]