User manual ZANUSSI FCS720C

[. . . ] WASHING MACHINE STIRALXNAQ MA{INA FCS 720C INSTRUCTION- A ND I N S TA LLA T I O N B O O K LET RUKOWODSTWO PO USTANOWKE I |KSPLUATACII 822 90 14-97 Contents For the User Safety information Description of the appliance -Machine front, Machine rear -Control panel For the Installer 3 4-5 Technical specifications Unpacking the machine -If the machine is damaged -When lifting the machine -Transit locking devices -Identification of materials 13 14 Programme chart General washing information -Detergent and fabric conditioner -Textile care labelling 6-7 8 Installation -Levelling the machine -Water intake -Water discharge -Power supply 15-16 Using your appliance -Loading the machine -Adding detergent and fabric conditioner -Starting the machine 9 Rukowodstwo po \kspluatacii 17 Maintenance 10-11 -The cabinet -The detergent dispenser -Inside the opening for the detergent dispenser -Cleaning inside the machine -Descaling -Protecting the machine against freezing If the machine is not working Service -Service and spare parts 12 13 This appliance complies with the following E. E. C. Directives: 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. -2- Safety information Before installing and first using the washing machine, read the instruction booklet carefully, including its hints and warnings. Doing so will ensure that your machine will perform properly and to best advantage. Anyone using the machine should be thoroughly familiar with its instructions for use and safety features. [. . . ] 100° can not iron A DRY-CLEAN P F can not dry-cleans normal temp. 4) and press any option buttons you require. Then press the ON/OFF button to start the wash. The indicator light will come on and after 5 seconds the door locks shut electrically and the machine starts working. -9- Maintenance The cabinet Clean the outside surfaces of the machine using a mild (non-abrasive) household cleaning product. Finish by removing remaining traces of the product with a damp cloth. Do not use cleaning products which contain alcohol (spirits), thinners and similar substances. 1 The detergent dispenser In time, residues of detergent and fabric conditioner are likely to build up inside the detergent dispenser. It should be cleaned at regular intervals by flushing it out with water. If necessary, the whole dispenser can be taken out of the machine for cleaning. You need to pull it firmly outwards, so that it comes free of a retaining stop (Fig. To remove the siphon (at the inside edge of the dispenser) for cleaning, you need to press it inwards and pull it upwards at the same time (Fig. When you put it back, press it downwards until you hear a distinct click. 2 Inside the opening for the detergent dispenser Detergent residues can also build up inside the opening for the detergent dispenser. You can use an old toothbrush for cleaning this area (Fig. When you have finished and put back the dispenser, run a short programme with no wash load in the machine to rinse it clean. 3 Cleaning inside the machine If you mostly use your machine for low-temperature washes, and/or if you use only very little detergent, you should clean the inside of the machine about once a month. This will prevent mould or stale odours from developing. Use the full recommended quantity of detergent and run a wash programme at the highest temperature with no wash load in the machine. - 10 - Descaling If your water supply is harder than 7° dH, you should descale your washing machine at least once every three months. 150 ml of citric acid instead of detergent and run a wash programme at the highest temperature with no wash load in the machine. Limescale deposits on components such as the machine's heating element will reduce their service life. (Contact your water company to find out the hardness level of your local water supply). Protecting the machine against freezing If the machine is kept in a place where the temperature may sometimes fall below 0°C, there is a risk that the small amount of water which remains inside parts of the machine after normal use will freeze and damage it. To prevent this you should: · Turn off the water supply to the machine and disconnect the water intake hose from the supply pipe. · Select a wash programme, start the machine and let the programme run for a short time. · Lower the tap end of the intake hose to floor level. Use a container such as a bowl to catch water running out of it. [. . . ] When the appliance location is on carpet floors, attention must be paid so as to ensure that there is no obstruction to the bottom vents. 1 Water inlet Connect the inlet hose to a tap with a 3/4" pipe thread. If necessary, use the restrictor (1/2") supplied (Fig. The inlet hose must not be joined onto any form of extension hose. If it is too short, the entire hose must be replaced with a longer high-pressure hose, specially designed for the purpose. [. . . ]