User manual ZANUSSI FJ1040-B

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid detergent). Press the function push button 2, the indicator lights of function push buttons 1 and 3 turn off while the indicator light of the function push button 2 goes on flashing, at the same time the end of programme indicator light illuminates indicating that the inflow of rinse aid is active. To deactivate the inflow of rinse aid, press the function push button 2 again, the end of programme indicator light turns off, indicating that the inflow of rinse aid has been deactivated. To memorise the operation, switch off the dishwasher by pressing the On/Off push button or wait about 60 seconds after which the dishwasher will automatically return to setting mode. To activate the inflow of rinse aid follow the above instructions until the end of programme indicator light illuminates. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades. BR09 Top up the rinse aid when the indicator light on the control panel illuminates. 9 In daily use q q q q Check if it's necessary to refill with special salt or rinse aid Load cutlery and dishes into the dishwasher. Select a wash programme suitable for the cutlery and dishes. US75 For taller items, the cup racks can be folded upwards. Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. Use of detergent Only use detergents specifically designed for use in dishwashers. Using no more then the correct amount of detergent contributes to reducing pollution. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Fill with detergent 1. If the lid is closed: press release button (1). Fill the detergent dispenser (2) with detergent. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent US74 Before closing the door, ensure that the spray arms can rotate freely. DE19 DE22 Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in upper basket lower basket 3. All programmes with prewash need an additional detergent dose (5/10 g) that must be placed in the prewash detergent chamber (3). This detergent will take effect during the prewash phase. Close the lid and press until it locks in place. With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. [. . . ] Check the water drain hose connection. Protection against flooding is active. Close the water tap and contact the service centre. Once the checks have been carried out, to continue the programme, press the push button of the programme that was running before the intervention of the alarm. The programme will continue from the point in which it was interrupted. If the fault code reappears contact your local service centre. For other combinations of fault codes not described in the above chart will appear, please contact your local service centre. . . . there are problems when operating the dishwasher Fault Possible cause The dishwasher door has not been properly closed. [. . . ]