User manual ZANUSSI FJ905N

[. . . ] WASHING MACHINE STIRALWNAÅ MAfiINA TVÄTTMASKIN PYYKINPESUKONE FJ 905 N F 805 N B 60°-95° B 30°-60° C 30°-40° A 60°-95° D F G J 30°-60° K 30°-40° L 30°-40° H 30°-60° M N P INSTRUCTION BOOKLET RUKOVODSTVO PO ÈKSPLUATACII BRUKSANVISNING 132998711 GB RUS S FIN KÄYTTÖOHJE Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. The symbols you will see on some paragraphs of this booklet have the following meaning: The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. [. . . ] To drain water and spin, depress button again. To drain only, select programme N. 4 Spin speed reduction button By depressing this button the final spin speed is reduced as follows: - from 900 to 650 rpm on programmes for cotton and linen - from 900 to 650 rpm in programmes for synthetics, delicates and wool. 8 Temperature selector dial Turn this dial to select the washing temperature. Position = cold wash. 9 Programme selector dial To select the required programme, turn this dial clockwise until the programme letter is exactly opposite the pointer. Before selecting a programme or changing a programme in progress the machine must be switched off by depressing ON/OFF button. 5 Quick wash button By pressing this button with programmes A-B for cotton and G-H for synthetics the wash time is reduced. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Maximum loads Recommended loads are indicated in the programme charts. General rules: Cotton, linen: drum full but not too tightly packed; Synthetics: drum no more than half full; Delicate fabrics and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size. 11 ENGLISH Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load, ­ the laundry is lightly soiled, ­ large amounts of foam form during washing. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. [. . . ] · The filter in the inlet hose is blocked. · The door is not properly closed. · The machine fills then empties immediately: · The machine does not empty and/or does not spin: · There is water on the floor: · The end of the drain hose is too low. Refer to relevant paragraph in "water drainage" section. · The drain hose is squashed or kinked. [. . . ]