User manual ZANUSSI FL503CN

[. . . ] >PE<= polyethylene >PS<= polystyrene >PP<= polypropylene s Ecological hints In order to obtain water and energy savings and Washing machine scrapping to protect the environment, we advice you to follow these instructions: s Whenever possible, wash the maximum load for the selected programme, without overloading the drum. s Use a programme with prewash only for heavy soiled items. s Measure out detergent according to the water hardness, degree of soiling and quantity of laundry being washed. s Select "Quick wash" for lightly soiled laundry. When the appliance is to be scrapped, cut off the power supply cable and make the door closing device inoperative to avoid it becoming a death trap for a child. [. . . ] Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated, i. e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. Run it along the floor; only the part near the drainage point must be raised. P0022 P0023 7 ENGLISH Electrical connection This machine is designed to operate on a 220230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (1. 75 kW), also taking into account any other appliances in use. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1362) fuse must be used. Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow - Earth Blue - Neutral Brown - Live The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load ­ the laundry is lightly soiled ­ large amounts of foam form during washing. Degrees of water hardness Degrees Level Characteristic German °dH French °T. H. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc. ), the colour, washing temperature and degree of soiling. All commonly available washing machine detergents may be used in this appliance: ­ powder detergents for all types of fabric, ­ powder detergents for delicate fabrics (60°C max) and woollens, ­ liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only. The detergent and any additives must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme. If using concentrated powder or liquid detergents, a programme without prewash must be selected. Pour liquid detergent into the dispenser drawer compartment marked just before starting the programme. Any fabric softener or starching additives must be poured into the compartment marked before starting the wash programme. [. . . ] s Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. Run the draining programme until the selector dial is in the "Stop" position. s Screw the inlet hose and reposition the drain hose. s When you intend to start the machine up again, make sure that the room temperature is above 0°C. 18 SOMETHING NOT WORKING Problems which you can resolve yourself s s Problem The machine does not start up: s s s Possible cause Check that the door is firmly closed. [. . . ]