User manual ZANUSSI TC180W

[. . . ] TUMBLE DR YER TC 180 822 90 13-75 Contents For the user Safety information Description of the appliance Using your appliance - Before you use the dryer for the first time - Capacity - Examples of laundry item weights For the installer 3 4-5 6 Technical specifications Unpacking the machine - Damages - Accessories - Identification of materials 14 15 Installation 7 8-9 - Positioning - Worktop installation - Wall mounting - Power supply 16-18 Programme chart Maintenance and cleaning - The filters - The condenser - Emptying the water tank Hints & Tips - Sorting - Spinning (water extraction) - Getting the load size right - Fluff - Shrinkage - Items which should not be tumble dried 10 Something Not Working?Service - Service and Spare Parts - Customer Care Department 11 12 Guarantee Conditions 13 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions Step by step instructions Hints and tips Environmental information -2- Safety information Before installing and first using the tumble dryer, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dryer are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the tumble dryer if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety. Installation and servicing s All installation and service work done on the product s Do not overload the dryer (see "Using your appliance"). [. . . ] Open the door and open the coarse filter upwards. Remove the fluff filter and close the coarse filter again. Grasp the recesses at the top of the condenser with your fingers and use your thumbs to press against the door (Fig. The condenser will come free, allowing you to lift it outwards/upwards. Be careful not to damage the sensitive aluminium section. Turn it upside down and clean it on both sides, using a vacuum cleaner. Remove the red drain plug on the lower edge of the condenser (Fig E). Lay the condenser flat and fill it with water through the filter opening. Now leave the condenser to soak in water for about 5 minutes, then shower both sides with hot water. Don't forget to put back the red drain plug (Fig. Make sure that its base is lined up in the slots in the condenser cavity inside the dryer door. Press the condenser carefully into place until you feel and hear a gentle "snap". Put back the fluff filter and close the coarse filter. D E F G -8- Emptying the water tank A warning light on the control panel will come on when it is time to empty the water tank. If it is operating when this happens, the dryer will stop automatically until the tank is emptied. It is a good idea to get into the habit of emptying the tank either before or after each load. Open the tank lid and pour the water out (Fig. Close the lid and push the tank back into place. If an engineer is called to resolve a problem listed below or to repair a fault caused by incorrect installation or mis-use a charge will be made, even if the appliance is under guarantee. Fault The machine will not start. Check s Is the door closed properly?s Have you set the program/timer knob properly?s Is the water tank full? The load is not drying properly, or is taking long time to dry. s Was the time set not long enough?s Is the load too large? Cotton max 3, 4 kg Synthetics max 1, 5 kg s Is the fluff filter clogged? s Is the condenser clogged?s Was the load not spun enough in the washing machine? [. . . ] Begin by placing the dryer on the worktop in the position where it is to be installed. Level the dryer with the aid of its adjustable feet. Mark the position for the hook on the wall. The correct place is opposite the centre of the lefthand bracket on the top rear of the dryer. [. . . ]