User manual ZANUSSI TD160T

[. . . ] Children should not be allowed to touch the controls or play with the product. Pets and small children may climb into tumble dryers. Check your appliance each time before use. s Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Make sure that the appliance does not stand on its electrical supply cable. [. . . ] If you take your appliance to a refuse disposal site, cut off the power cable flush with the appliance to avoid the danger of the appliance being reused, and disable the door catch to prevent children becoming trapped inside. s USE s s s s s s s s s s 38 INSTALLATION Positioning The appliance may be placed in any room, provided the following precautions are taken. The appliance expels hot, very moist air. The rest of the house must be able to easily absorb this moisture. Normally, absorption is only possible in houses where there is very little humidity. Otherwise, the room must have ventilation towards the outside; generally, an open door or window is enough. The capacity of the venting circuit must be at least 150 m3/hour. Check that the air inlet and outlet vents are unobstructed. The best way of evacuating the moisture is through a vent hose to the outside of the building. Use a special 100 mm diametre flexible hose, available through your dealer, connected to one of the air outlet vents with the collar supplied. Advice: If the hose is long and the room temperature low, the moisture might condense to water inside the hose. This is an unavoidable natural phenomenon. When the door is refitted, it will be at the top (fig. - Remove the screws (3), the plastic plate (4) and (5) with a screwdriver, taking care not to damage the cabinet (fig. Refit the parts on the opposite side (fig. - Refit the door by screwing in the two screws (1) which fasten the door to the cabinet (Fig. B). P0281 Important When operating the tumble dryer, the room temperature must not exceed 35C, as it may affect the performance of the appliance. To save energy, the room temperature should not be lower than +15C. Levelling Level the tumble dryer into place by screwing or unscrewing the front feet as required. Accurate levelling will keep vibration and noise to a minimum when the dryer is in use. P0883 2 5 1 3 4 A P0046 5 Electrical connection 4 3 2 1 This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply. P0884 B Check that your domestic electrical installation can take the maximum load required (2. 2 kW), also taking into account any other appliances in use. Connect the machine to an earthed socket, in accordance with current wiring regulations. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution. 40 Control panel COTTONS ALGODO-LINHO 5 kg 800 1000 1200 800 1000 1200 85 -100 80 - 95 75 - 90 50 - 60 45 - 55 40 - 50 30 - 40 20 - 30 20 - 25 min. min. 75 - 90 70 - 85 65 - 80 35 - 45 30 - 40 25 - 35 min. min. 2 kg SYNTHETICS SINTTICOS 2 kg 1 kg 0, 5kg AUTOREVERSE T DS 360 T 1 2 3 USE OF CONTROLS 1 Programme Chart This will help you to select the correct time for drying. 3 Drying Time Selector Dial The selector dial incorporates two drying cycles, one of up to 120 minutes at a high temperature (blue section) for cotton and linen, and one of up to 80 minutes at a low temperature (green section) for synthetic fabrics. [. . . ] Select time s Turn the selector dial clockwise to the required minute setting (in the high or low temperature range, according to the fabric): the mains-on light illuminates and the machine starts operating. When the selector dial is in position , the heating element is switched off and the laundry is cooled for 8 minutes. At the end of this phase the machine stops: the programme is completed. Important: It is not advisable to open the door during operation to check the degree of dryness. [. . . ]