User manual ZANUSSI TD62

[. . . ] We promise that it will provide a superior User Experience delivering Ease-of-Mind. Good luck ! 4 contents Contents Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Description of the appliance . . . . . . . . . . . . . . 8 Washing guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The maximum speed is 600 rpm for all the programmes. At the end of the programme, if you have selected "Rinse hold" or "Night silence plus", you then need to select a "Spin" or "Drain" programme to finish the cycle. "Rinse hold" The washing machine will not drain the water from the last rinse, so will not crease the laundry. Selecting options You must select the different options after selecting the programme and before pressing the "Start/ Pause" pushbutton (see "Programme table"). Press the desired button(s) ; the corresponding lights come on. If one of the options is not compatible with the selected programme, the "Start/Pause" pushbutton flashes red. "Prewash" option The appliance runs a prewash at 30°C max. The prewash finishes with a short spin cycle for cotton or synthetic programmes, and with an empty cycle for delicates programmes. "Light/Super quick" option The cycle can be made longer or shorter by pressing the "Option" pushbutton to choose "Light" or "Super quick". By default, all indicators are switched off. Light : Lightly soiled laundry Super quick : Very lightly soiled laundry or half load The availability of these different levels varies depending on the selected programme type. "Extra rinse" option The washing machine will add one or more rinses during the cycle. Turn the programme selector to the "Off" position. Remove washing Unplug and close water inlet tap. We recommend leaving the lid and drum open after use to ventilate the water tank. Standby mode If the appliance is on but no commands are selected for 10 min before or after a cycle, it goes into standby mode. All the lights go out and "Start/Pause" flashes slowly. To exit standby mode, simply press any pushbutton or turn the programme selector. 12 washing guide Washing guide Sorting and preparing the washing · Sort washing by type and care label (refer to International symbols section below) : normal wash for tough fabrics which can withstand intense washing and spinning cycles ; delicate wash for delicate fabrics which need to be treated with care. For mixed loads, loads with items of different types of material, choose a programme and a temperature suitable for the most fragile material. · Wash whites and colours separately : Otherwise, whites will be coloured or will turn grey. · New coloured clothes often contain excess dye. It is recommended to wash such items separately the first time. Follow care instructions "wash separately" and "wash separately several times". · Empty pockets and unfold items. · Remove loose buttons, pins and fasteners. [. . . ] · the drainage pump is blocked, · the standpipe is blocked. · the water inlet tap is closed, · the water supply has been cut off. the wash cycle is much too long : The washing machine stops during a wash cycle : The lid doesn't open at the end of the cycle : The "Start/Pause" pushbutton** flashes red*** : The "Start/Pause" pushbutton** flashes red***: The "Start/Pause" pushbutton** flashes red***: operating problems 19 Problems Softener runs directly into the drum when filling the dispenser box : Causes · you have gone past the MAX indicator. * Depending on model. **On some models, the audible signals can sound. *** After solving any problems, press the `Start/Pause' pushbutton to restart the interrupted programme. 20 technical specifications / installation Technical specifications DIMENSIONS Height Width Depth 850 mm 400 mm 600 mm 230 V / 50 Hz 2300 W Minimum Maximum 0, 05 MPa (0, 5 bar) 0, 8 MPa (8 bar) 3/4" BSP LINE VOLTAGE / FREQUENCY POWER CONSUMPTION WATER PRESSURE Connection to water supply This appliance conforms to the CEE 89-336 directive concerning the limiting of radio-electric interference and the 2006/95/CE directive concerning electrical safety. Installation 3 4 Remove all protective packaging for transit before using for the first time. [. . . ]