User manual ZANUSSI TDS362T

[. . . ] power absorbed Cotton, linen Synthetics 85 cm 60 cm 57 cm 220-230 V/50 Hz 2200 W (10A) 5 kg 2. 5 kg ELECTRICAL CONNECTION DRYING CAPACITY This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Stacking kit A special stacking kit is available through your dealer, to enable the mounting of the dryer on top of your washing machine. 3 ENGLISH WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. [. . . ] To prevent this water from Iying in the hose or flowing back into the tumble dryer, it is advisable to drill a small hole (dia. 3 mm) in the lowest point of the hose and to place a small container below it. (See picture, point A). Problems can be encountered in rooms fitted with a very powerful central extractor fan. If you find that drying times are too long, switch off the extractor or close its grille whilst the tumble dryer is in use. A highly effective solution is to simply poke the vent hose through a window or skylight. This might however cause problems in winter because the dryer will draw in very cold (and often also very damp) air through the open window, so increasing drying times and leading to very high energy consumption. If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. It the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption. If the hose is completely squashed, the safety cutouts with which the machine is fitted may operate. Condensation discharge through the vent hose Condensation may be discharged either through a vent outlet provided at the back or through the left or right side outlet. The vent hose collar is placed in the rear vent outlet. Remove the collar by pulling it out of the vent outlet. Fit the hose into the required vent outlet and stop the unused outlets with the covers provided for such a purpose. P0330 A P0751 Connect the other end of the hose to an opening in a door or window. Fit a suitable shield or point the hose downwards to prevent any rain water and wind from getting in. Rain and wind shields for placing over openings usually consist of valves or movable flaps. Periodically check the shield since strong winds and other factors (rust, dirt) can sometimes prevent it from opening, so causing problems with air venting. If you use a rain shield, check that the openings in it are large enough to allow air to escape. Openings which are too small restrict the flow of air. The vent hose must not contain more than two bends when it is placed in position for operation. A P0279 You should NOT connect the flexible vent hose to, for example, a chimney or flue pipe designed to carry the exhaust from a fuel burning heating appliance. P0055 5 ENGLISH The tumble dryer must be installed in a clean place, where dirt does not build up. Make sure there are no obstructing items or material near the air-intake louvres provided at the back (e. g. paper, rags etc. ). Door reversal To make it easier to load or unload the laundry the door can be reversed. This operation must be carried out by qualified personnel. Operate as follows: - Remove the door by unscrewing the two screws (1) fastening the hinge to the cabinet (Fig. - Remove the safety catch (2) and the plug (3) by bending the two fastening tags (Fig. [. . . ] It is perfectly normal for fluff to accumulate in the filter during drying. In fact, even fabrics dried in the open air lose their fibres, but we do not notice it. External cleaning Use only soap and water and then dry thoroughly. From time to time, apply a little wax furniture cream with a soft cloth. Important: do not use methylated spirit, diluents or similar products. Cleaning the door Clean periodically the interior part of the door to remove any fluff. [. . . ]