User manual ZANUSSI Z1162TRM

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. · Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. [. . . ] Use only special salt suitable for dishwashers. Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT!Top up the special salt when the light on the control panel illuminates. 10 Use of rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close the lid and press until it indicated by "max" locks. IMPORTANT!Top up the rinse aid when the light on the control panel Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid deter- illuminates. This would damage the appliance. Adjusting the dosage of rinse aid Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades. Open the lid. Set the dosage level. (The Close the lid and press undose is factory set in po- til it locks. We recommend every 3 months to run the wash programme for heavy soiled dishes using detergent but without dishes. External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of nonoperation If you are not using the machine for any prolonged period of time you are advised to: 1. Unplug the appliance and then turn off the water. 16 2. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. 1. Remove the water inlet and discharge hoses. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. Moving the machine If you have to move the machine (moving house etc. . . . ): Environmental concerns Packaging material The packaging materials are environmentally friendly and can be recycled. The plastic components are identified by markings, e. g. [. . . ] The plug must be accessible after the appliance has been installed. Never unplug the appliance by pulling on the cable. The manufacturer accepts no liability for failure to observe the above safety precautions. Fitting under a counter By removing the dishwasher's worktop, you can install it under a close fitting sink unit or a preexisting top. Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required. 23 Levelling Good levelling is essential for correct closure and sealing of the door. [. . . ]