User manual ZANUSSI Z140T

[. . . ] This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] Refer to your local Service Centre, and always insist on genuine spare parts. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials; it must nevertheless be disposed of in a proper manner, in accordance with regulations for protection of the environment. 25 INSTALLATION If this model, equipped with a magnetic door lock, replaces an old appliance with a catch, ensure that the latter cannot be used before discarding it to prevent children being trapped inside. GB Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ± 6% of the rated value. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. 87/308 of 2/6/87 concerning the suppression of radio interference. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. Ensure that air can circulate freely around the back, top and bottom of the cabinet. If the appliance is positioned below an overhanging kitchen unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (Fig. The ideal solution, however, is the one shown in Fig. The appliance can be installed with its sides touching adjacent kitchen units provided that air can circulate freely around the back and top. Accurate levelling is ensured by one or more adjustable feet at the base of the refrigerator. Cleaning Before using, clean all inside parts with warm water and neutral detergent to remove the typical new smell. [. . . ] Clean the outside with a silicone wax spray. Clean the condenser and compressor with a brush or vacuum cleaner. This will improve performance and consequently save on electricity. The light bulb The opening on the diffuser gives access to the light bulb. [. . . ]