User manual ZANUSSI Z20-10PR

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] The selected delay time value will appear on the display for a few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 8. You can cancel the delay time at any moment, before you press button 8. If you have already pressed it, and you wish to cancel the delay time, proceed as follows: · set the washing machine to PAUSE by pressing button 8; · press the button 10 once. On the display will appear the symbol «0'». · press button 8 again to start the programme. · If the programme has already started, the selected delay can be modified only after you have turned the programme selector dial to the «O» position and after you have selected the programme again. · The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 8, the pilot light 9 goes off and the door can be opened. After you have closed the door, press the same again. The Delay Start cannot be selected with «Drain» programme. turn the programme selector dial to «O» 2. select the «Drain» or «Spin» programme 3. reduce the spin speed, if needed, by means of the button 2 4. at the end of programme, the display shows a flashing zero «0», the light «Door Locked» goes off and it will be possible to open the door. At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. 17 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. [. . . ] Do not use the hose from your previous machine to connect to the water supply. Open the porthole and extract the inlet hose. 2. Connect the hose with the angled connection to the machine. 45° Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. [. . . ]