User manual ZANUSSI Z710SD

[. . . ] Ensure that the appliance does not stand on the electrical supply cable. If the supply cable is damaged, it must be replaced by a cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Parts which heat up should not be exposed. [. . . ] Use the compartment for foods that are marked typically for storage at 0-5°C for longer preservation. Adjusting the fridge temperature to cooler or warmer affects the chiller temperature in the same way. Avoid stacking large amounts of warm food on top of already cold food, as this will raise the temperature of the food previously stored in the chiller. Do not use the chiller, as a zone for rapid cooling at it is not designed for this. 5 Food Storage Energy Saving Advice Do not install the cabinet close to sources of heat, such as a cooker, dishwasher or radiator. Locate the appliance in a cool well-ventilated room and make sure that the air openings of the cabinet are not obstructed. Avoid unnecessary frosting in the cabinet by packing all foodstuffs into airtight packages before placing them in the freezer. Always leave warm food to cool down to room temperature before placing in the fridge or freezer. Food that is to be frozen (when cool) should be placed in the fridge before being transferred to the freezer. Do not put any hot food into the fridge or freezer. This will ensure safer defrosting of foods and reduce the work of the refrigeration unit. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Switch off the appliance by pressing the ON/OFF button, and then unplug the appliance. Open the plastic light cover, by pushing upwards on the centre clip. Unscrew the light bulb and replace with a bulb with the following specifications: Clear Halogen E14 screw thread 220-240 Volts 25 watts (max) Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). Increase the room ventilation. The appliance does not cool down sufficiently The doors have not been closed properly A door has been opened frequently The temperature control knob is not set correctly Food has been introduced into the appliance Food is freezing in the fridge The temperature control knob is incorrectly set Food is too close to ventilation holes at the back The motor works continuously. Temperature control knob is incorrectly set The doors are not properly closed Doors have been opened frequently Food has recently been introduced into the appliance The condenser is dirty Water/condensation in the vegetable drawer Condensation on the outside of the cabinet Doors do not close Wet vegetables have been put into the box High humidity level in the room. The appliance is not level The doors are incorrectly aligned Food is preventing the doors shutting Level the appliance correctly Re-align the doors Re-position food Level the appliance Check the contents and shelves are properly positioned. Contact your local Service Force Centre Noises The appliance may not be level Something may be vibrating inside All product lights start flashing and the alarm sounds 8 Your product has a major fault Normal Operating Sounds 1. Temperature control Cooling system Motor Fans May cause clicking sounds when the system is connected or disconnected. The injected cooling gas may produce a gurgling sound while passing through the tubes. May cause a humming noise and or slight knocking sound. You may occasionally hear the fans working. This is normal; the fans help to ensure the air circulates more effectively. Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. The addresses are listed on the following pages. Before calling out an engineer, please ensure you have read the details under the heading «Something Not Working». When you contact the Service Centre you will need to give the following details. Your name, address and postcode Your telephone number Clear and concise details of the fault The model and serial number of the appliance (found on the rating plate) The purchase date Customer Care Department Customer Care Department Zanussi 55-77 High Street Slough Berkshire SL1 1DZ 08705 727727 * For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www. zanussi. co. uk * Calls to this number may be recorded for training purposes. 9 GUARANTEE CONDITIONS Standard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. [. . . ] (Fig 3) Climate Classification SN N ST T Ambient Operating Temp. +10 to +32°C +16 to +32°C +18 to +38°C +18 to +43°C rating plate Fig. 3 If the temperature rises above or falls below the stated ambient temperature for the climate class, the operation of the appliance may be affected. Ventilation You should also ensure that air can circulate freely around the back and the top of the cabinet. Never put something on the ventilator grill of the appliance (see fig. [. . . ]