User manual ZANUSSI Z9020TD S.INOX

[. . . ] Remove all loose items, including food, store food in a cool place. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing. Remove the freezer door by releasing it from the middle hinge (H). Slide out the fridge door from pin (G), unscrew pin (G) and then screw it down into the hinge hole provided on the opposite side, after having removed the small plugs which should then be fitted on the opposite side. [. . . ] To switch off the appliance turn the thermostat control to position "G" Setting the temperature The temperature inside the appliance is regulated by a thermostat with 6 temperature positions and an "OFF" (O) position. Position 1 = minimum coldness Position 6 = maximum coldness Turn the thermostat control knob to the required position. The intermediate position is usually the most suitable (3-4). The thermostat control knob regulates the temperature both within the fridge and the freezer compartment. The thermostat setting can vary as the temperature inside the appliance depends on the following factors: ­ room temperature ­ how often the door is opened ­ how much food is stored ­ position of the appliance 16 5 Use of an air circulation slider control - COOL FLOW CONTROL MIN MAX GUARANTEE CONDITIONS COOL FLOW CONTROL Your appliance has an air circulation slider control situated at the rear of the fridge compartment, which controls the amount of cold air circulated through the fridge compartment. When the ambient temperature is between 10°C and 16°C, the slider control should be in the "MIN" position. When the ambient temperature is above 16°C the slider control should be midway between "MIN" and "MAX". When the ambient temperature is very high (i. e. hot summer days) position the slider control to "MAX". D757/1 Standard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of the purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. MIN MAX COOL FLOW CONTROL The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. All service work under this guarantee must be undertaken by a Zanussi Service Force Centre. The appliance should be left overnight and the cool check examined in the morning. If the cool check shows TOO WARM, turn the thermostat to a colder setting leave overnight and examine again the following morning. The freezer door will not open The compressor runs continously Has door just been opened?If so leave for a few minutes to allow the air pressure to equalise. Adjust the thermostat control knob to give correct temperature control. See "Setting the temperature". Large quantities of food have recently been placed in the cabinet and/or door is frequently opened. Check that air vents is not obstructed. Hints and Tips · · · The guide is only suitable for use in the model supplied. The guide will not operate in the freezer compartment. When cleaning the shelf take care not to immerse in water, and wipe away any spills. Noise Refer to normal operating sounds. If, after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. [. . . ] Take care not to let the meat juices drip onto other food. If the meat does drip, remove everything and clean thoroughly. The best way to defrost food is to put it in the refrigerator to thaw slowly. Remove suspect food from your refrigerator and clean (refer to "Maintenance and Cleaning). [. . . ]