User manual ZANUSSI ZA18

[. . . ] - - - - - - - - - - - - - - - - - - - - 24 Technical data- - - - - - - - - - - - - - - - - - - - - 27 Consumption values - - - - - - - - - - - - - - - - 28 Installation instruction - - - - - - - - - - - - - - - 29 Environmental concerns - - - - - - - - - - - - - 33 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] If you need to open the door, you must first set the washing machine to PAUSE by pressing button 8. The door can be opened immediately or after a few minutes depending on the model. (In any case do not try to open the door if it is locked!). After you have closed the door, press the same again. The Delay Start cannot be selected with «Drain» programme. Altering an option or a running programme It is possible to change some option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing button 8. Changing a running programme is possible only by resetting it. Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by pressing button 8 again. The washing water in the tub will not empty out. Interrupting a programme Press button 8 to interrupt a programme which is running, the corresponding light starts to flash. Turn the selector dial to «Cotton» or «Synthetics» programme in the «Drying» sector. For the timed drying, press the button 5 until the time you want appears on the display (see the drying programmes). Every time you press this button the drying time increases by 5 mins. The programme time will automatically increase by up to 2 minutes. The different type of cottons (towelling, sheets, shirts, and so on) or eventual laundry rolling up during spinning phase may cause a not uniform dryness. So, in the exceptional case that at the end of the cycle the laundry remains slightly wet, we suggest you to stretch the items rolled up out, to redistribute evenly the laundry in the drum and to select an additional drying cycle of 20-30 minutes. After the programme has started, the time remaining is updated every minute. At the end of the programme, the buzzer sounds. A flashing zero «0» will appear on the display. At this point, begins the anti-crease phase which lasts for about 10 minutes. During this time the light 9 is alight, the door cannot be opened and the display keeps 20 showing three flashing zeros «0». [. . . ] The recess should have the dimensions shown in picture A. 600 600 in. 515 596 600 m 416 818 120 541 8 160 When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped. Preparation and assembly of the door The machine is originally pre-arranged for the assembly of a door opening from right to left. In this case it is sufficient to screw in the hinges (1) and the counter-magnet (6) provided with the appliance, at the right level (Fig. [. . . ]