User manual ZANUSSI ZAC131

[. . . ] - - - - - - - - - - - - - - - - - - - - 21 Technical data- - - - - - - - - - - - - - - - - - - - - 24 Consumption values - - - - - - - - - - - - - - - - 25 Installation instruction - - - - - - - - - - - - - - - 25 Environmental concerns - - - - - - - - - - - - - 31 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, cleaning and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Some acustic signals sound and on the display will appear a flashing «0 ». The light of button 8 and the light 9 go off. If at the end of a programme there is water in the tub, the light 9 remains on and the door is locked to indicate taht the door must be empty out. To empty out the water follow the following instructions: 1. turn the programme selector dial to «O» 2. select the draining or spinning programme 3. reduce the spin speed, if needed, by pressing the button 2 4. at the end of programme, the display shows a flashing zero «0», the light 9 goes off and it will be possible to open the door. At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Drying only and autodrying (NON-STOP programme) The recommended load to dry in your washerdryer is 3 kg for cotton and 2 kg for synthetics. Select the required options by pressing the relevant buttons. The display shows the entire duration of the washing and the selected drying cycle. If possible, do not select a spin speed lower than that proposed by the appliance to avoid a too long drying time so saving energy. In any case the reduction of the spin speed is only possible after selecting drying. Start the programme by pressing the button 8. After the programme has started, the time remaining on the display is updated every minute. 7. At the end of the programme the buzzersounds. A flashing zero «0» appear on the display. At this point of the programme, starts an anti-crease phase which lasts about 10 minutes. During this time the door is locked and the display keeps showing the flashing zero «0». (If you wish to open the door before or during the anti-crease phase, please follow the instructions given in the previous chapter). [. . . ] The required dimensions are given in the picture C. The hinges will be fixed to the door by means of screws for wood (2-Fig. c) Mounting the door Fix the hinges (1) to the machine by means of 29 416 818 120 820 min 176, 5 416 C 22+1 , 5 B 195 the M5x15 screws (3-Fig. The hinges can be adjusted to compensate for possible uneven thickness of the door. [. . . ]