User manual ZANUSSI ZAC164

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. ried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. Always insist on genuine spare parts. General safety · Dishwasher detergents can cause chemical burns to eyes, mouth and throat. [. . . ] Keep the button pressed until the programme selector To memorise the operation, turn the programme seindicator light and the start/cancel indicator light start lector dial to position off. flashing. Filling with dishwasher salt CAUTION!Use only special salt suitable for dishwashers. Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT!Top up the special salt when the light on the control panel illuminates. Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close the lid and press until it indicated by "max" locks. 10 CAUTION!Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid detergent). This would damage the appliance. Top up the rinse aid indicator (B) becomes clear Adjusting the dosage of rinse aid Increase the dose if there are drops of water or lime spots on the dishes after washing. Arrange serving dishes and large lids around the edge of the basket. 12 Load upper basket. NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing comwater. partment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. 15 Cleaning the spray arms NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove them with a cocktail stick. 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. [. . . ] The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks. Drain hose Connect drain hose to the Required height: 30 to 100 Ensure that the hoses are When connecting the sink. cm above bottom of the not kinked, crushed or en- drain hose to an under dishwasher. sink trap spigot, the entire plastic membrane (A) must be removed. [. . . ]