User manual ZANUSSI ZAC52

[. . . ] Do not put any solvents in the dishwasher. Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. Only use products (detergent, salt and rinse aid) suitable for dishwashers. Avoid opening the door whilst the appliance is in operation, hot steam may escape. [. . . ] Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades. Open the lid. Set the dosage level. (The dose is factory set in position 4). Close the lid and press until it locks. Loading cutlery and dishes The following items are not suitable for use in the dishwasher: - Cutlery with wooden, horn, china or mother-of-pearl handles - Plastic items that are not heat resistant - Older cutlery with glued parts that are not temperature resistant - Bonded cutlery items or dishes - Pewter or copper items - Lead crystal glass - Steel items prone to rusting - Wooden platters - Items made from synthetic fibres When loading the dishwasher, make sure that you: - Remove all left over food and debris. - Soften remnants of burnt food in pans - Load hollow items such as cups, glasses, pans, etc. with the opening downwards so that water cannot collect in the container or a deep base. - Dishes and items of cutlery must not lie inside one another, or cover each other. - To avoid damage to glasses, they must not touch. - Lay small objects in the cutlery basket. Plastic items and pans with teflon have a tendency to retain water drops; these items will not dry as well as porcelain and steel items. IMPORTANT!Before closing the door, ensure that the spray arms can rotate freely. 10 Load cutlery. For best results we recommend you to use the cutlery grid provided (if the size and dimensions of the cutlery allow it). Place knives and other items of cutlery with sharp points or edges with their handles facing upwards. Risk of injury! Load the lower basket. Arrange serving dishes and large lids around the edge of the basket. Load upper basket. Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. For taller items, the cup racks can be folded upwards. If plates are to be loaded in the upper basket: load them starting from the rear positions; tilting them slightly forwards and avoiding the front positions near the door. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in: upper basket lower basket With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm 11 IMPORTANT!The water drain hose has not been correctly laid or it is bent or squashed. Check the water drain hose connection. Close the water tap and contact your local Service Force Centre. Close the door Insert the mains plug The fuse has blown in the household Replace the fuse. If dishes are to be washed immediately, cancel the delay start. Once these checks have been carried out; close the door, switch on the dishwasher and press the start/cancel button. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre. For other combinations of fault codes not described in the above chart, please contact your Service Force Centre. 15 The wash results are not satisfactory The dishes are not clean The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The spray arm do not rotate freely due to wrong arrangement of the load. The filters in the base of the washing compartment are dirty or incorrectly positioned. Too little or no detergent has been used. [. . . ] The dishwasher incorporates adjustable feet to allow the adjustment of the height. During all operations that involve accessibility to internal components the dishwasher has to be unplugged. Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required. 20 Guarantee/Customer Service Standard guarantee conditions We, Zanussi-Electrolux , undertake that if within 12 months of the date of the purchase this Zanussi-Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OFCHARGE for labour, materials or carriage on condition that: · The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. · The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. [. . . ]