User manual ZANUSSI ZAC98

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] For more information about the compatibility of the options with the washing programmes, refer to the section «Programme table». Select the delayed start by pressing the button 10 Depress this button to select the required delay. The selected delay time value will appear on the display for few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 8. You can cancel the delay time at any moment, before you press button 8. If you have already pressed it, and you wish to cancel the delay time, proceed as follows: · set the washing machine to PAUSE by pressing button 8; · press the button 10 once. On the display will appear the symbol «0'». · press button 8 again to start the programme. · If the programme has already started, the selected delay can be modified only after you have turned the programme selector dial to the «O» position and after you have selected the programme again. · The door will be locked throughout the delay time. If you need to open the door, you must first set the washer dryer to PAUSE by pressing button 8. The door can be opened after a few minutes. (Pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then to press button 8. At the end of the programme The washer dryer stops automatically. Some acustic signals sound and on the display will appear a flashing «0 ». The button 8 light and the light 9 go off. If, at the end of a programme, there is water in the tub (light 9 still on), to empty out the water follow the following instructions: To empty out the water: 1. turn the programme selector dial to «O» 2. select the «Drain»or «Spin» programme 3. reduce the spin speed, if needed, by means of the button 2 4. at the end of the programme, the display shows a flashing zero «0», the light 9 goes off and it will be possible to open the door. Turn the programme selector dial to «O» to switch the machine off. [. . . ] Connect the hose to a tap with a 3/4" thread. Always use the hose supplied with the appliance. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. 45° Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. [. . . ]