User manual ZANUSSI ZB1421T

[. . . ] edge, unless they have been given supervision or Prior to installation instruction concerning use of the appliance by a perCheck the appliance for transport damage. Under no son responsible for their safety. circumstances should a damaged appliance be installed. In the event of damage please contact your During Use retailer. [. . . ] Servicing This product should be serviced by an authorised engineer and only genuine spare parts should be used. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Force Centre. At the end of the Appliance Life When disposing of your appliance use an authorised disposal site. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. 3 Remove the plug and ensure that any locks or catches are removed, to prevent young children being trapped inside. Safety precautions for isobutane Warning The refrigerant isobutane (R 600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. Ready-cooked foods, convenience foods, fresh meat, cold cuts Do not store uncovered food. Remove suspect food from your refrigerator and clean, refer to cleaning and maintenance. Energy Saving Advice Do not install the cabinet close to sources of heat, such as a cooker, dishwasher or radiator. 7 Locate the appliance in a cool well ventilated room and make sure that the air openings of the cabinet are not obstructed. Always leave warm food to cool down to room temperature before placing in the fridge. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to often switch on unnecessarily. Ensure there are no obstructions preventing the door from closing properly. It is advisable to periodically clean the refrigeration system at the back of the appliance with a duster or vacuum cleaner. External Cleaning Wash the outer cabinet with warm soapy water. There are sharp edges on the underside of the product so care should be taken when cleaning. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. Changing the Light Bulb Should the light fail to work you can change it as below: Disconnect the appliance from the electricity supply. Remove the lamp cover retaining screws, then take the lamp cover off in the direction of the arrow and the bulb can be changed. (Type of the bulb: 230 V, 15 W, E 14 thread) After changing the bulb replace the lamp cover, and retaining screws and reconnect the appliance to the electricity supply. Maintenance and Cleaning Before any maintenance of cleaning work is carried out DISCONNECT the appliance from the ELECTRICITY SUPPLY. Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5 ml to 0. 5 litre of water). Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol. [. . . ] Set the thermostat control knob to a lower position. Check nothing is preventing the door from closing. Check the door gasket is intact and clean. Check if the appliance stands stable (all four feet should be on the floor). The temperature in the appliance is too low Excessive frost and ice has built up The thermostat control is set too high. [. . . ]