User manual ZANUSSI ZC18/9 1

[. . . ] · This appliance has been designed for use by adults. Take care therefore, that children do not attempt to play with it. · When receiving the appliance, unpack it on the spot. Check the general aspect of the appliance. [. . . ] It is not necessary to preheat the oven. Turn the thermostat on position . fig. 5 Grilling 9 Heat comes from the top of the oven. It is suitable for grilling meat (beef bacon, pork bacon . . . ) that remains tender, for toast or to brown already cooked. When using the grill it has to be supervised, the oven door opened the protective screen in its place. Roast meat 3 · · · · · · · · · · · Prepare the meat to be roasted, lightly brush it with oil on both sides. Slide the dripping pan in the guide 1 Slide the pan support grid in the guide 2 or 3 depending on the thickness of the meat to be roasted. Use guide 3 for the thin pieces to be roasted (toasts, pork bacon, sausage, small fish. . . ) Use guide 2 for thick pieces to be roasted (beef bacon, large fish, poultry). When the first side is brown, turn the meat without pricking it in order that the juices are not lost. Salt when ending the cooking. 2 1 fig. 6 Cooking time has to determined by the thickness of the piece to be roasted not by its weight. Frying · · · · Fix the protective screen. Place the dish on the grid and slide it in the guide 2 or 3. Before igniting make sure the flame splitter and the caps are properly replaced. Self-cleaning oven (just for the model: ZC 560) Principle: The walls of your cooker, except the soil are protected by special porous enamel. It absorbs and destroys the fat splashes when warm. Maintenance Sometimes when cooking causes a lot of fat projections (poultry, roasted meat . . . ), the time or the temperature are not always enough for eliminating the fat. In this case, after cooking remove all the accessories from the oven (grid, dripping tray), fix the thermostat on position "250" and leave it function empty for 45 min, then select position . . . If you start this operation from cold oven count 60 minutes for cleaning. The soil which is not self cleaning enameled can be pulled out, if necessary, for dripping. Anyhow, it has to be cleaned separately, before starting the self-cleaning, in order to avoid burning of dirt. In case of overflow on the soil clean with a sponge and a mild detergent. Do not project cleaning products on the part covered with self-cleaning enamel. The oven door is hotter the usually, do not allow children near the appliance. [. . . ] Flexible pipe · Flexible pipe (mechanic connection) max length 1. 5 m; · We advice to use a flexible pipe, according to the national rule in force, not shorter than 1 m, depending on the position of the tap; · Connect one end of the pipe to the blocking tap, than, before placing the appliance between the furniture, connect the other end to the pipe extension, inserting a gasket. Fitting Connection gas Pipe flexible Necklace Pipe flexible Pipe flexible 19 · Place the cooker checking that the loop made by the flexible pipe develops in the sanitary empty of the furniture. Fitting Rigid pipe · Rigid pipe with screw nut Holder butane 2. For cylinder butane propane gas: · We advise you to use flexible pipe according to the national rule in force of minimum 1 m; this length is chosen depending on the position of the connection to the gas supply; For the old butane installations you can use a flexible rubber pipe of max 1, 5 m and 6 mm diameter, mounted with the special butane holder ; Fix it well by means of a collar for each end. Flexible rubber Necklace · Electrical connection Important In any connection way the appliance has to be grounded, in accordance with the national rules in force and with standard NFC 15 100. We decline any responsibility in case of accidents due to no grounding or wrong grounding. · For buying the pipe · Flexible rubber hose: it has to be marked NF GAS · Flexible pipe: according to standard NF D 36 121, or NF D 103, or NF D 36 107 Fuse capacity: 16A Note: Check on the rating plate the value for the total connection power for establishing the fuse power. In case of a direct connection to the mains you have to interpose an omnipolar switch a minimum opening between contacts of 3 mm. [. . . ]