User manual ZANUSSI ZC280R

[. . . ] Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. ¥ Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation ¥ There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. [. . . ] Refer to your local Service Centre, and always ¥ ¥ ¥ Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Use ¥ The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Frozen food must not be re-frozen once it has been thawed out. ManufacturersÕ storage recommendations should be strictly adhered to. The inner lining of the appliance consists of channels through which the refrigerant passes. If these should be punctured this would damage ¥ ¥ ¥ 9 CONTENTS Warnings Use Cleaning the interior Operation Temperature regulation Fresh food refrigeration Movable shelves Positioning the door shelves Hints Hints for refrigeration Maintenance Periodic cleaning Periods of no operation Interior light 9 11 11 11 11 11 11 11 12 12 12 12 12 12 Defrosting Customer service and spare parts Installation Location Electrical connection Rear spacers Changing the opening direction of the door 12 13 13 13 14 15 15 10 USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. ¥ ¥ ¥ how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. If there are water drops on the bottom of the cabinet, check that the defrost water drain opening is not obstructed (see ÒDefrostingÓ section). ¥ If your appliance is still not working properly after making the above checks, contact the nearest service centre. To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom left-hand side. INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18¡C and +43¡C(class T); +18¡C and +38¡C (class ST); +16¡C and +32¡C (class N); +10¡C and +32¡C (class SN). The class of your appliance is shown on its rating plate. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (A). Ideally, however, the appliance should not be positioned below overhanging wall units (B). Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. 100 mm A 10 mm B 10 mm NP006 13 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. [. . . ] Directives: - 87/308 EEC of 2/6/87 relative to radio interference suppression. - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 14 Rear spacers In the bag with the documentation, there are two spacers which must be fitted in the two top corners. Slacken the screws and insert the scraper under the screw head, then re-tighten the screws. D594 Changing the opening direction of the door Before buiding-in the appliance (if necessary), change the opening direction of the door. Remove the lower hinge (1) and feet (3) 2. [. . . ]