User manual ZANUSSI ZCA93X

[. . . ] Operating and assembly instructions CERAMIC BUILT-IN HOBS GB ZCA 93 B/W WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. [. . . ] Put it in between the frame and worktop on the area where the snapin ressorts are located. In terms of fire protection, the appliance conforms to type Y (IEC 335-2-6). Only appliances of this type may be installed on one side of adjacent upright furniture housings or walls. 5 Fig. 2 sealing ceramic worktop Fig. 4 ELECTRICAL CONNECTIONS WARNING: EARTHED. THIS APPLIANCE MUST BE Fig. 1 Electrical connection 1 L 2 3 N 4 5 Supply system Single Phase The manufacturer declines any liability should this safety measure not be observed. Ensure that the electric circuit is capable of carrying the load of the appliance. Switch OFF the electricity supplies at the mains. A double pole cooker control switch with a suitable electrical rating should be used to control the electrical supply to the hob. The control switch should be easily accessible to the user on completion of the installation. The control switch must not break the yellow/green earth wire at any point. To wire the hob, carefully place the unit, face downward on a flat surface with the control area overhanging, to avoid damage to the controls. Remove the screws securing the cover to the terminal box, remove the cover and connect the supply cable via the cable clamp (Fig. 1), to the terminals provided. The supply cable should be 6mm2 or its equivalent. Connect the earth wire to the terminal marked with the letter "E" or with the earth symbol or coloured green. Connect the live wire to the terminal marked with the letter "L" and coloured brown or red. Connect the neutral wire to the terminal marked with the letter "N" and coloured blue or black. Tighten the terminal screws and the cable clamp, then refit the terminal plate cover. You must ensure that the cabinet is stable and level. This appliance complies with EEC Directive number 76/ 889 and amendment 82/499 relating to the suppression of radio and TV interference. Rating plate The rating plate is situated on the underside of the unit and gives the type and serial number as well as the model description of the appliance (which should be quoted in any communication). Note: This appliance must be connected to a separate 30 AMP switch outlet. Important: The appliance must be connected to a cooker point, having a double pole isolating switch with a contact separation of at least 3mm in all poles. 6 OPERATION Cooking Zones The hob has 4 ceramic cooking zones. [. . . ] Cleaner Conditioner has been specially formulated, use only as much as necessary. If the Ceaner Conditioner is used too generously, a heavy film may be left that will burn on and discolour when the areas are heated. When this occurs, lightly scrub the surface with a dampened non-stick pan cleaner, this will help to loosen the excess Cleaner Conditioner. Then wipe the surface with a dampenend cloth and polish with a soft dry cloth. [. . . ]