User manual ZANUSSI ZCM930X

[. . . ] MIXED FUEL COOKER ZCM930X INSTRUCTION BOOKLET GB Please read this instruction booklet before using the appliance. IMPORTANT SAFETY INFORMATION You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 727727. Installation · This cooker must be installed by qualified personnel, according to the manufacturer's instructions and to the relevant British Standards. Any gas installation must be carried out by a registered CORGI installer. Remove all packaging before using the cooker. [. . . ] Turn the oven function to Fan oven and the temperature control knob to the correct setting. The clock will work out what time the oven will switch itself on and will switch the oven off at the end. An audible signal will sound when cooking is complete. To cancel the sound, see below. 14 Returning The Cooker To Manual Or To Cancel An Automatic Programme Once automatic cooking is complete an alarm will sound and the Auto symbol will flash to remind you that the oven needs to be set for manual operation. To do this press buttons 2 and 3 and together. After a few seconds the timer will show the time of day. The cookpot will show in the display and the oven will switch on again. Turn off the oven control. To Set The Timer To Switch Off Only This is useful if you want to begin cooking immediately but have the Main Fan oven switch off whilst you are out. Ensure the clock is showing the correct time of day. Set the length of time you want the food to cook for. Press and release button 2 and then within 5 seconds press the button until the correct cook time is showing. After a few seconds the time of day shows in the display. Turn the oven temperature control to the required setting. If you want to check the time the oven will switch off simply press the button and the 'Stop' time will be displayed. At the end of the cook time the oven will switch off, the alarm will sound and the auto symbol will flash. To cancel and return to manual operation press buttons 2 and 3 together. Turn off the oven temperature and oven function control knobs. 15 MAINTENANCE AND CLEANING The oven should be kept clean at all times. A build-up of fats or other foodstuffs could result in a fire, especially in the grill pan. Before cleaning, ensure all control knobs are in the OFF position, and the appliance has cooled completely. Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply. Cleaning materials Before using any cleaning materials on your oven, check that they are suitable and that their use is recommended by the manufacturer. Cleaners that contain bleach should NOT be used as they may dull the surface finishes. [. . . ] If a cooker hood is installed above this cooker it must be a 90cm hood and installed according to the manufacturer's instructions. 26 GAS CONNECTIONS Your cooker is delivered adjusted for the kind of gas stated on the rating plate If the appliance is supplied with natural gas and the pressure for natural gas is 20mbar. The following method of connection to the gas supply must be used: Rigid Connection Where it is not possible to make the connection using a rubber hose, a rigid pipe work connection must be used. Recommendations when using an appliance flexible connector are as follows: - For NATURAL the gas installation pipes to the termination point shall comply with: Specification for installation of low-pressure gas pipe work of up to 20mm (R1) in domestic premises (2nd family gas) ­ BS 6891;. Connection shall be by means of an appliance flexible connector for use with a self-sealing plug-in device, complying with: Flexible hoses, end fittings and sockets for gas burning appliances ­ BS 669; The appliance flexible connector should not be subjected to undue forces either in normal use or whilst connected or disconnected; - The socket which the plug of the appliance flexible connector fits should be permanently attached to a firmly fixed gas installation pipe and positioned such that the appliance flexible connector hose hangs freely downwards. [. . . ]