User manual ZANUSSI ZD19/4

[. . . ] If these should be punctured this would damage the appliance beyond repair and cause food loss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Frost may be removed by using a plastic scraper. Under no circumstances should solid ice be forced off the liner. [. . . ] Remove the centrai hinge and detach the upper door from the pin (G). Unscrew the pin (G) and screw it into the corresponding position on the opposite side, after having removed the plugs which must be refitted on the other side. Remove the two plugs, and remount them on the other side. D715 PIED/M Environment Protection G This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. CONTENTS Warnings 3 Use Cleaning the interior Operation Temperature regulation Fresh food refrigeration Freezing fresh food Storage of frozen food Thawing Ice-cube production Air recycling Movable shelves Positioning the door shelves Freezing calendar Hints 2 3 3 3 3 4 4 4 4 4 5 5 5 5 6 Hints for refrigeration Hints for freezing Hints for storage of frozen food Maintenance Periodic cleaning Periods of no operation Interior light Defrosting Customer service and spare parts Installation Location Rear spacers Electrical connection Door reversal 6 6 6 7 7 7 7 7 8 9 9 9 9 10 1 2 7. Re-assemble the upper door, the centrai hinge and the lower door. Re-assemble the lower hinge (1) and the support foot (2) on the opposite side. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E. E. C. Directives: - 87/308 EEC of 2/6/87 relative to radio interference suppression. - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 45° PR60 Thawing Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. 4 9 Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. [. . . ] unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. Hints for freezing To help you make the most of the freezing process, here are some important hints: · · the maximum quantity of food which can be frozen in 24 hrs. [. . . ]