User manual ZANUSSI ZD21/5RM

[. . . ] Do not place heavy articles or the fridge/freezer itself on the power cord. Do not remove the power cord by pulling on its lead, particularly when the fridge/freezer is being pulled out of its niche. If the power plug socket is loose, do not insert the power plug. If the power cord is damaged, it must be replaced by a certified service agent or qualified service personnel. [. . . ] mIt is essential that the appliance be connected to an D594 efficient earth tap. · Make sure the refrigerator is accurately levelled turFor this purpose the supply cable plug incorporates ning the adjustable feet in order to avoid vibrations a special earth contact. domestic wiring system are not grounded, have the · This is a built in design to be aligned with other furniappliance connected to a separate ground wire in ture. accordance with existing safety regulations. · «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED». Starting ­ up · Plug the appliance into the mains. · Turn to intermediate position the knobs of the «temperature regulators» «A» Fig. 2 · Make sure the inner light «H» turns on when opeThe appliance should be only set up at a location ning de door. whose ambient temperature corresponds to the clima18 Changing the opening direction of doors and Panelling If you wish to change the opening side of the doors proceed as follows: 1. . . Remove the handles of the doors, if they are side fixing by screws. Remove the inferior hing taking care for the downer door not to fall off and not to lose the plastic spacer. Using a 10mm spanner, unscrew the hinge pin and reassemble it on the opposite side. Maintain food for at least 24 hours in that position. The maximum quantity to be frozen within 24 hours is shown on the «Rating Plate», depending on the model. Keeping frozen food For optimum consevation, the temperature inside the freezer compartment must be at least -18°C. This temperature is adjusted automatically. Check that the «Temperature Control» is in a middle position. Sometimes it may be necessary (insufficient ventilation, high roon temperature, frequent opening and closing of the door. . . ) to change the position of the «Temperature Control». If the appliance should be accidentally switched off by a fault or power cut, take the following precautions: · Keep the doors closed at all times. · Find out how long the stoppage is expected to last. Once normal power is restored: A) If the freezer is full and the stoppage has been less than «Time for temperature Rise» indicated for each model in the «Technical Features» section, then no damage will have been caused to the food. B) If the freezer is not full, the cold will be lost more quickly. If the food has not started to thaw, then follow the instructions in «A». C) If the food has begun to thaw, use them up as quickly as possible, or cook them and refreeze them. ColdStore Compartment (some models) The models equippied with this feature in the fridge part, it is indicated for a best conservatiom of fresh foods as fish, meat seafood, etc. [. . . ] · Leave the door ajar to permit the air to circulate in the interior and thus avoid unpleasant smells. 25 Something not working Some functioning problems may be due to causes which can easily be solved before calling the Network Service. Follow theses instructions: Problem A) INTERNAL LIGHT 1. Inner light (Refrigerator compartment) does not come on «H». Cause · Appliance unplugged. · The temperature regulator is on "0" position Solution · Plug the appliance into mains. [. . . ]