User manual ZANUSSI ZD604W

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q q Do not sit or stand on the open door. Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] The On/Off indicator light remains on until the On/Off push button is depressed. 10. Ensure that the spray arms can rotate freely. Measure out detergent Add the detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart. Switch off the dishwasher by pressing the On/Off push button and open the door. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 5. 6. 7. Close the dishwasher door Set the programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. If necessary select the temperature of the main wash according to the instructions in the "Washing programmes" chart (see "Required push buttons"). When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. Important!Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 13 SEQ12en Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend the use of Finish Dishwasher Cleaner every 3 months or run a 65°C wash without dishes using detergent. Switch off the water supply and clean the filter. Clean the filters (refer to "Maintenance and cleaning"). Ensure the crockery is loaded correctly. The drain hose extension is not correct. Follow the instructions for connecting to the waste. There is no vent in the end of the drain hose. Dishes are rattling against each other, refer to "Loading your machine". The spray arms are knocking against the dishes. Refer to "Loading your machine". The dishwasher is not level, or not properly built-in. Check that there is salt and that the salt cap is tight. [. . . ] A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. + II76 596 5 57 x ma 818 - 878 0 5 55 x ma 600 Adjusting the height of the appliance To adjust the height proceed as follows: 1. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. A pad is supplied for the rear foot to make sliding the appliance in and out of the recess easier. To fit the pad, press it onto the rear foot. [. . . ]