User manual ZANUSSI ZD606B

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q q Do not sit or stand on the open door. Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] As phosphates have water softening properties, we suggest you add salt to the salt container even if the hardness of your water is as low as 8°TH. This will avoid lime deposits on crockery and the inner tub. 10 M M IN AX DET05en Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see "Washing Programmes" chart) so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. Do not prewash dishes under running water. Items not suitable for dishwashers The following items should not be washed in the dishwasher (unless they are sold as dishwasher proof): - Cutlery with wooden or horn handles or glued parts - bronze cutlery - saucepans with wooden handles - aluminium ware - crystal ware - leaded glass - plastic items - antique or fine decorated china Certain types of decoration can discolour when washed in a dishwasher. Crystal-ware and plastic objects, if not guaranteed dishwasher proof should be washed by hand. The On/Off indicator light remains on until the On/Off push button is depressed. 2. Check that there is rinse aid and salt Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 10. Switch off the dishwasher 3. Switch off the dishwasher by pressing the On/Off push button and open the door. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge hoses. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. 15 MAN03en Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made even if the appliance is in guarantee. Symptom The machine will not start q q q Solution The door has not been properly closed. The plug is not properly inserted in the power socket. Ensure the mains water supply has not been cut off. Switch off the water supply and clean the filter. Clean the filters (refer to "Maintenance and cleaning"). [. . . ] Directives: - 73/23 or 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 22 COLUKen Building-in This dishwasher is designed to be fitted under a kitchen counter or worksurface. It is essential that the recess dimensions indicated in the diagram are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm). [. . . ]