User manual ZANUSSI ZD686B

[. . . ] DISHWASHER ZD 686 152980 57/0 INSTRUCTION BOOKLET UK Contents For the user Important safety information Description of the appliance The control panel Before use Setting the water softener Filling with salt Rinse aid Using your appliance Loading your appliance The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Hints and tips Washing programmes Operating sequence Maintenance and cleaning Internal cleaning Cleaning the filters External cleaning Prolonged periods of non-operation Frost precautions Moving the machine Something not working Service and spare parts Customer Care Department Guarantee conditions Zanussi Service Force Hints for test centres Technical specifications 3 4 4 5 5 6 7 8 8 8 8 9 9 10 11 12 13 14 14 14 15 15 15 15 16 17 17 18 19 21 21 For the installer Installation instructions Water supply connections Water outlet hose connection Electrical connection Building-in 22 22 23 24 25 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions 1. Step by step Hints and tips Environmental information 2 IND35en Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. [. . . ] To remove the drain filter - simply pull it out by the handle. Once cleaned, refit the filter by pushing it back to its original position until it engages. MA04 A MA19 Cleaning the large filter (Every week) If necessary clean the large filter (B) on both sides under running water, using a brush. Remove the spray arm by pulling it upwards on one side. Turn the column (C) anticlockwise by 90° and then slide out the filter. MA05 90° B C MA20 3. Once cleaned refit it following the above instructions in reverse order. Ensure the filter is in its original position, the handle of the drain filter should be pointing towards the front of the appliance. MA21 MA18 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 14 MAN04UKen External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge hoses. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. 15 MAN03en Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made even if the appliance is in guarantee. Symptom The machine will not start q q q Solution The door has not been properly closed. The plug is not properly inserted in the power socket. Ensure the mains water supply has not been cut off. Switch off the water supply and clean the filter. [. . . ] If required, the dimensions of this pads can be reduced by breaking it where marked. II52 Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. IN11 IN12 25 820 - 880 INS59UKen The furniture door The door on this appliance is designed for the overlay of a panel having the following dimensions: Width Height Thickness Weight 596 mm 604 mm max 20 mm max 2 - 7. 5 kg max The height of the panel depends on the height of adjacent kitchen units (see kitchen plinth adjustment). The panel height should be no more than indicated, otherwise complete opening of the door will not be possible as the furniture door panel will hit against the dishwasher plinth. [. . . ]