User manual ZANUSSI ZDC5355W

[. . . ] 125992770. qxp 2004-09-07 07:53 Page 1 TUMBLE DRYER ZDC 5355 W Memory2 Memory1 Cooling 30 min 60 min Baby Iron dry Reset/ Off Cotton extra dry Ready to wear Store dry Slightly damp Door Iron dry Machine iron dry Store dry Synthetic extra dry Spin Option Change Exit Start/ Pause TIMELINE AUTOREVERSE 6 kg ZDC 5355W Unpacking: see page 23 125992770 INSTRUCTION BOOKLET GB 125992770. qxp 2004-09-07 07:53 Page 2 Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Installation · This appliance is heavy. [. . . ] Turn the selector dial, in order to select the desired programme. The relevant message will appear in the display. The display will show the end cycle time «Cycle end at» of the selected programme, calculated on the basis of the maximum load for each type of fabric. The START/PAUSE button light will start flashing. If the load of laundry to be dried is small, at the beginning of the cycle the display will still indicate the end cycle relevant to the maximum load. 12 125992770. qxp 2004-09-07 07:53 Page 13 The duration value will be gradually adjusted during the execution of the drying cycle. Memory 2 Memory 1 Cooling 30 min 60 min Baby Iron dry Store dry Reset/ Off Cotton extra dry Ready to wear Store dry Slightly damp Iron dry Machine iron dry Synthetic extra dry Cotton extra Cycle end at 1200 Door Spin Options Change 08. 30 10. 55 10. Press the START/PAUSE button. The message relevant to the phase that is in progress will be shown in the display. If you have chosen a delayed start, the tumble dryer will begin the countdown. Start/ Pause Exit Cotton extra Drying 1200 Door Spin Options Change 08. 30 10. 55 Exit 7. Press the SPIN button repeatedly, in order to select the real spin speed that your laundry has been spun. The selected spin level will be shown on the third row above to the spin button. Cotton extra Cycle end at 1200 Door Spin Options Change 08. 30 10. 55 Exit 8. Press the «Options» button to select the required options. To confirm your choice press the «Change» button. Depending on the selected programme only certain options are available and shown during the selection phase. Note: Not all the options are compatible between themselves. The incompatible option icons will disappear. Select the DELAY START option if required. Before you start the programme choose the required option. The selected delay time value (up to 20 hours) will appear on the display while selecting. The end cycle will be updated and shown on the relative position of the display. Delay Start No 10. 55 Delay Start Start in 30 min 11. 25 Door Spin Options Change Exit Door Spin Options Change Exit If the programme selector dial is turned to another position, when the machine is running, the buzzer will sound and the «Selection error» message appears in the display. The drum turns alternately in both directions during drying. All drying programmes end with a 10 minute cooling phase (on the second row of the display appears the «Cooling» message). You may remove the laundry after this phase. The display shows the following messages one after an other: «Please clean the filters» and «Please empty the tank». [. . . ] Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat build-up which would interfere with the operation of the appliance. [. . . ]