User manual ZANUSSI ZDC57L

[. . . ] Care should be taken when · · · · · moving it. It is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] We therefore recommend that you adopt the following guidelines: · cotton, linen: drum full but not too tightly packed; · synthetics: drum no more than half full; · delicate fabrics: drum no more than one third full. 11 Operating Sequence Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes. There may be dust inside a brand new tumble dryer. Example: Press the «Change» button until the desired language appears in the display. Drying 1. Open the door (see picture). Language ENGLISH Sprache DEUTCH Temp. Spin Options Change Exit Temp. Spin Options Change Exit A Press the EXIT button to confirm the selection. Einstellungen P1149 P1108 Temp. Spin Options Change Exit 3. Load the items one at a time, shaking them out loosely. Please check the laundry does not get caught between the door and filter. Turn the selector dial to the desired programme to switch the appliance on. To switch the appliance off turn it to «Reset/Off». Memory 2 Memory 1 Cooling 30 min 60 min Baby Iron dry Store dry Reset/ Off Cotton extra dry Ready to wear Store dry Slightly damp Iron dry Machine iron dry Synthetic extra dry B Switching on the appliance for the first time. Language When switching on the appliance for the first time you must set the language in which you want the indicators on the display to appear. If the display is not showing any language, the appliance has already been switched on once. In such case, go to the chapter «Change language» if you would like to change the language setting. All indicators on the display will appear in this language from now on. You may remove the laundry after this phase. The display shows the following messages one after an other: «Please clean the filters» and «Please empty the tank». The buzzer sounds to indicate the end of the cycle. 11. If the laundry is not removed at the end of the cycle, the dryer performs an anti-creasing phase (duration: 30 minutes maximum). If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase. The display will show the following messages one after an other: «Anticrease», «Please clean the filters» and «Please empty the tank». The buzzer sounds to indicate the end of the cycle. The light of the START/PAUSE button goes off and a flashing zero appears on the display. 12. Turn the programme selector dial to "RESET/ OFF"; all the lights go out. If you open and then close the door before turning the programme selector dial to "RESET/OFF", the machine is ready to perform another drying programme. The display shows the selected programme, duration of the programme and the options required. 13 After each use · Clean the filters (see page 16). [. . . ] The tumble dryer must be installed in a clean place, where dirt does not build up. Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grill or the air intake grills at the back of the machine. To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. [. . . ]