User manual ZANUSSI ZDI4041N

[. . . ] DISHWASHER ZDI 4041 Instruction book en Contents Important safety information Description of the appliance The control panel Before use Setting the water softener Filling with salt Rinse aid Use of detergent Using your appliance Loading your appliance The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Hints and tips Washing programmes Operating sequence Maintenance and cleaning Internal cleaning Cleaning the filters External cleaning Prolonged periods of non-operation Frost precautions Moving the machine Something not working Service and spare parts Protection against fooding 3 4 4 5 5 5 6 6 7 7 7 7 7 7 8 9 10 11 11 11 11 11 11 11 12 12 13 Installation instructions Water supply connections Water outlet hose connection Electrical connection Hints for test centres 14 14 14 15 15 Technical specifications Dimensions Width Height with worktop Max depth Max depth with open door Voltage 44. 6 cm 81. 8 - 87. 8 cm 57. 5 cm 111. 4 cm 230 V - 50 Hz 200 W 1900 W 2100 W 50 kPa (0. 5 bar) 800 kPa (8 bar) 8 place settings Electrical connection Motor rating during wash Power of heating element Overall power Water supply pressure Minimum Maximum Capacity This appliance complies with the following E. E. C. Directives: - 73/23 of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 2 Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. [. . . ] Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. 2. Check that there is rinse aid and salt 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart. Close the detergent dispenser lid. 6. Set the programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. 8. Start the programme Depress the On/Off push button. The On/Off indicator light will come on and the machine will start. If you wish to interrupt the washing programme at any time press this button again. 9. At the end of the washing programme At the end of the programme the dishwasher will automatically stop. The On/Off indicator light remains on until the On/Off push button is depressed. 10 Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash without dishes using detergent. External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Cleaning the central filter (After each wash) Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water. Filters (B) and (C) are both removed by lifting up the outer one (B) (pulling the central funnel upwards); the smaller filter (C) can be removed by pressing the two tongues (D). Once cleaned, refit the filters by pressing them down until they click into place. Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. [. . . ] This will prevent deposits of sand or rust clogging the inlet hose filter. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4 inch gas thread spout, or to a purpose made quick-coupling tap such as the Press-block. Do not use, for connection, old hoses which have been used in another appliance. The water supply hose is fitted with a safety device, which prevents water from entering the machine should the inner hose split, due to wear. [. . . ]