User manual ZANUSSI ZDI6896QX

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. q Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local consumer services department. [. . . ] Using no more then the correct amount of detergent contributes to reducing pollution. Use of "3 in 1" combi detergent tablets General advice These products are tablets with combined detergent/rinse-aid and salt functions. Before using these products you should first check that the water hardness in your supply is compatible with the use of these products as per the detergent manufacturers (on the product packaging). These products should be strictly used according to the detergent manufacturers instructions. Do not place the tablets in the tub or in the cutlery basket as this will result in poorer wash results. The tablets should be placed in the detergent dispenser. If you encounter problems when using 3 in 1 products for the first time then please contact the detergent manufacturers care line (the telephone number is given on the product packaging). Fill with detergent Prior to the start of a wash programme. The detergent is released during the washing phase. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Open the dispenser by pulling the catch (D). Fill the detergent dispenser with detergent. The marking indicates the dosing levels: Min = approximately 15 g of detergent Max = approximately 30 g of detergent 3. q Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point in which it was interrupted. q Pressing the On/Off push button (in this case the On/Off indicator light turns off). Press the On/Off push button again; the programme will start from the point in which it was interrupted. 6. End of the washing programme The dishwasher will automatically stop at the end of the programme. The On/Off indicator light remains illuminated until the On/Off push button is depressed. Switch off the dishwasher by pressing the On/Off push button. Hot steam may escape from the appliance when opening the door immediately after the end of the programme, therefore, open the door carefully. Unloading the dishwasher Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. Leave the dishes in the dishwasher for approx. 15 minutes, with the door ajar, after the end of programme so that they dry better and will be cooler. [. . . ] The retaining ring (A - ) must be properly fitted so as to avoid water leaks. Fixing to the adjacent units The dishwasher must be secured against tilting. Therefore make sure that the counter it is fixed under, is suitably secured to a fixed structure (adjacent kitchen units cabinets, wall). A 2 B A C B 1 CA13 Note!Only for water supply hoses with Lock-fast safety device to prevent inadvertent loosening. To detach the hose press yellow lever (C - ) and turn the retaining ring anticlockwise . 15 Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. [. . . ]