User manual ZANUSSI ZDRA600X

[. . . ] Refer to your local Zanussi Service Centre. Always insist on genuine Zanussi spare parts. Ensure that all control knobs are in the OFF position when not in use. Should you connect any electrical tool to a plug near this cooking appliance, ensure that electric cables are not in contact with it and keep them far enough from the heated parts of this appliance. [. . . ] Viale Bologna 298 - 47100 FORLI' (Italy) 1. Instruction for the User HOB BURNERS CONTROL KNOBS The hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply LIGHTING THE BURNERS · For easier lighting, proceed before putting a pan on the pan support. · Use only pans or pots with flat bottom. Carefully supervise cookings with fats or oil, since these types of foodstuff can result in a fire, if overheated. Push the electric ignition push botton which is marked by a little spark. At the same time, turn the relevant controlo knob anticlockwise to maximum position and keep it pushed down for about 5 seconds. This will allow the "thermocouple" (Fig. D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. Then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" (Fig. To put the flame out, turn the knob to the symbol . Screw the parts without forcing, adjust the connection in the required direction and tighten everything. IMPORTANT - When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Use some soapy water, never a flame. A) Ramp with ending nut B) Seal C) Adjustable connection FO 0264 Fig. Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label); 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. The appliance is supplied with a connection cable. This has to be provided with a proper plug, able to support the load marked on the identification plate. To connect the plug to the cable, follow the recommendation given in Fig. The plug has to be fitted in a proper socket. If connecting the appliance directly to the electric system, it is necessary that you install a double pole switch between the appliance and the electricity supply, with a minimum gap of 3 mm. [. . . ] Finally check the flame does not go out when quickly turning the knob from the maximum position to the minimum position. 8 by-pass screw Table 1 : By-pass diameters Burner Ø By-pass in 1/100 of mm. 28 42 · This procedure can easily be carried out, anyhow the hob has been positioned or built in the working top. Table 2 : injectors BURNER NORMAL POWER kW REDUCED POWER kW Auxiliary Rapid NORMAL POWER NATURAL GAS G20 - 20 mbar inj. [. . . ]