User manual ZANUSSI ZDT5895

[. . . ] DISHWASHER ZDT 5895 BUI LTIN 1 PRE-W 2 INTEN ASH 3 NORMA SIVE 4 BIO L 65 5 ECO WITH PREWA 60 WITH PREWA SH 45 SH 50 6 BIO 7 ECO 8 DELIC 9 QUICK ATE 45 50 45 45 Z D T 5 8 9 5 153 1123 13 INSTRUCTION BOOK GB Dear Customer Please read these operating instructions carefully. Please make sure you read the safety instructions on the first pages of these operating instructions!Keep the operating instructions for future reference. With the warning triangle and/or by means of key words (Warning!, Caution!, Important!), information is emphasized which is important for your safety or the correct functioning of the appliance. [. . . ] Press the dispenser lid shut. Use of 3 in 1" / Combi Detergent Tablets General Advice These products are tablets which contain detergent, rinse-aid and a softening agent. Before using these products you should first check that the water hardness in your area is compatible with the use of these products as per the detergent manufactures instructions (on the product packaging). These products should be used according to the detergent manufacturers instructions. Do not place the tablets in the tub or the cutlery basket as this will result in poor wash results. The tablets should be placed in the detergent dispenser. If you encounter problems when using "3in1" products for the first time, then please contact the detergent manufacturers care line (the telephone number is given on the product packaging). Special Advice When using combination products, the rinse-aid and salt indicator lights are no longer useful. It may be helpful therefore to select the lowest possible setting for rinse-aid and water hardness. If you decide to switch to the use of a standard tetergent system, we advise that you: refill both the salt and rinse aid compartments. switch the water hardness setting to the highest possible position and run for three normal cycles without a load. re-adjust the setting according to the water hardness in your area (as per the instruction manual). - 16 Selecting and starting the programme 1. Use the programme selection button to select the desired programme. The selected programme and control lamp will flash on the control panel. The door lock must latch, otherwise the machine will not start. Do not open the door after the programme has started!To prevent scolding and damage to units by escaping steam. Control lamp for programme selection Programme selection button Start time / Remaining time display / Error message Delay start The start of the selected programme can be delayed between 1 and 9 hours in steps of 1 hour using the "DELAY START" button. By repeatedly pressing the button "DELAY START", the delay time can be programmed in hours, and will be displayed in the display field. The control lamp flashes until the door has been closed. Delay start control lamp Delay start button Before washing commences the door can be opened without the programme being lost. After the pre-selected start time has expired, the machine starts up the selected programme automatically. 17 Programme selection / Correcting or deleting delay start 1. The time remaining before washing commences is indicated on the control panel. [. . . ] Green and Yellow -Earth Blue -Neutral Brown -Live The wire coloured green and yellow must be connected to the terminal marked with the letter "E" or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal "N" or coloured black. The wire coloured brown must be connected to the terminal marked "L" or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. [. . . ]