User manual ZANUSSI ZDT6254

[. . . ] GESCHIRRSPÜLER DISHWASHER ZDT 6254 D GB Bedienungsanleitung Instruction book Contents Safety instructions Description of the appliance The control panel Prior to using for the first time Setting the water softener Filling with salt Rinse aid In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Washing programmes Starting a washing programme Maintenance and cleaning Cleaning the filters Prolonged periods of non-operation Frost precautions Moving the machine What to do, when. . . Service and spare parts Security system 18 19 19 20 20 21 21 22 22 22 22 23 23 24 25 26 27 27 27 27 27 28 29 29 Installation instructions Building-in Levelling Fixing to adjacent units Water supply connections Water outlet hose connection Electrical connection Hints for test centres 30 30 30 30 30 30 31 31 Technical specifications Dimensions Width Height Max depth Max depth with open door 59. 6 cm 81. 8 - 89. 8 cm 55. 5 cm 111. 4 cm Electrical connection: Voltage Overall power Fuse Water supply pressure Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher's door on the right. Minimum Maximum 50 kPa (0. 5 bar) 800 kPa (8 bar) 12 place settings Capacity This appliance complies with the following E. E. C. Directives: - 73/23 or 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 17 Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. [. . . ] For this reason 50°C wash programmes in which concentrated detergents are used can achieve the same results that can otherwise only be achieved using 65°C programmes. Detergent tablets Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot develop their full cleaning power during short programmes. Therefore please use normal programmes with prewash when using detergent tablets. 24 Washing programmes Programme Type of load and degree of soil Required programme push button Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Rinse and Hold Any. Partial load (to be completed later in the day). 1 cold rinse (to avoid food scraps from sticking together). Hot prewash Main wash up to 70°C 2 cold rinses 1 hot rinse Drying Warm prewash Main wash up to 65°C 2 cold rinses 1 hot rinse Drying Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying Main wash up to 55°C 1 cold rinse 1 hot rinse 12 0, 02 6 Intensive 70° Heavy soil. Crockery, cutlery, pots and pans 100 - 110 1, 8 24 Normal 65° Normal soil. Crockery and cutlery 85 - 95 1, 7 20 (1) Bio 50° Normal soil. Crockery and cutlery 91 - 101 1, 24 19 (2) Quick wash 55° Light soil. Crockery and cutlery 45 - 55 1, 1 12 (1) Testing programme for EN 50242 (see "Hints for Test Centres). This programme, developed for the use of detergents with enzymes, allows to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of the programme has been extended. (2) This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. (3) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. 25 Starting a washing programme In this fully integrated appliance, the controls are located on the top of the door. When selecting a programme, the door needs to be slightly open. 6. End of the washing programme The dishwasher will automatically stop and an intermittent audible signal will be heard when the programme has ended. The indicator light of the programme just ended turns off and the "end of programme" indicator light starts flashing. Wait until the end of the audible signal before opening the door. (Note: if during the end of programme audible signal the door is opened, the dishwasher will anyhow complete both audible signal and programme) Hot steam may escape from the appliance when opening the door immediately after the end of the programme, therefore, open the door carefully. Open the door and switch off the dishwasher by pressing the On/Off push button or select a new washing programme by pressing one of the programme push buttons. 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Press the On/Off push button The On/Off indicator light comes on 4. Setting and starting the programme Press the programme push button which corresponds to the programme you wish to select (see "Washing programmes" chart). [. . . ] A hot water supply is not always efficient with very soiled crockery as it shortens the washing programmes a lot. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4" inch gas thread spout or to a purpose made quick-coupling tap such as the Press-block. The water pressure must be within the limits given in the technical specifications. Your local Water Authority will advise you on the average mains pressure in your area. [. . . ]