User manual ZANUSSI ZF134UN

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation There are working parts in this product which heat up. [. . . ] Remove the four screws which fix the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that fix the upper hinge to the appliance and remove the hinge itself. D447 Fig. 3 17 Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 4), and, using the screws removed from the lower part, fix it to the base of the appliance itself. Remove and refit the other hinge on the upper part of the appliance on the opposite side. Fix the two front screws into the upper and lower hinges (Fig. Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and fit the insert supplied with the appliance on the opposite side. Fig. 4 D510 Fitting a decorative door panel Important: The components needed to fit the decorative panel have been pre-fitted on the appliance. The brackets are secured to the panel by means of the 7 Ø 3. 5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins pre-fitted on the appliance door. The small bottom bracket need not be removed. Place the appliance in the position where it is to be built in (Fig. The appliance is fitted with adjustable feet; screw the front and rear feet in or out to adjust the height of the appliance to that of the recess. = Fig. 5 A = Keeping the appliance central in the recess, slide it in until its back touches the wall. With a tape measure (or similar instrument), measure distance (A) between the top edge of the door and the top edge of the decorative panel, placing it next to the recess. D467 18 Lay the panel face down (Fig. Position the top bracket on the panel, making sure that there is an equal distance between it and the sides and that its distance from the top edge is equal to distance (A) less 1 cm. Secure the bracket with the screws supplied. Take care not to damage the front face of the panel whilst working. = = Fig. 6 A -1cm D468 Insert the adjusting pins (B-Fig. 7) into their locations in the door and screw them in. B Fig. 7 D532 Hook the decorative panel onto the top part of the door, inserting the pins (B) (on the door) into the elongated holes (1) (in the top bracket fitted to the panel) (Fig. [. . . ] If a thick layer of ice has formed, complete defrosting will be necessary. Proceed as follows: switch off the appliance by means of the ON/OFF switch; wrap frozen food in several sheets of newspaper and put it in a very cool place; leave the door open; once defrosting has been completed, thoroughly dry the inside of the freezer; keep the scraper for future use; move switch (D) to the ON position; turn knob (C) to the required setting. Set the appliance to run on fast freeze. After three hours, return switch (A) to the normal position. [. . . ]