User manual ZANUSSI ZF47-55

[. . . ] m Make sure that the power plug is not squashed or damaged by the back of the fridge/freezer. Do not place heavy articles or the fridge/freezer itself on the power cord. Do not remove the power cord by pulling on its lead, particularly when the fridge/freezer is being pulled out of its niche. If the power plug socket is loose, do not insert the power plug. [. . . ] 2 · This is a built in design to be aligned with other furniture · The appliance must be located in places of maximum temperature as follows: SN N ST T +10 +16 +18 +18 hasta hasta hasta hasta +32ºC +32ºC +38ºC +43ºC Starting ­ up · Plug the appliance into the mains. · Make sure the inner light turns on when opening the door. · Turn to intermediate position the knobs of the «temperature regulator» «A» (See Control And Use paragraph). If the temperature are higher than these both above mentioned, the functions of appliance coudl result reduced. 4 Control and Use Control Temperature Regulator for Refrigerator: «A» Allows to adjust the temperature inside the refrigerator according to use and external conditions. 0 = Motor disconnected. Inner Door Compartments Position The door compartments can be pulled up and removed and inserted at other positions as needed. PR270 Shelves Position Y X The storage shelves can be adjusted to various heights. Interior light: Comes on when opening the door of the refrigerating compartment. When changing the light bulb, first remove the protective cover «X» after pull out the screw "Y" . Dinamic Refrigeration (DAC): Its use is particularly suitable: · In hot weather (ambient temperature of over 25º) and when a lot of foodstuffs have just been stored. · In damp atmospheres (if a lot of frost forms on the back wall of the refrigerator cabinet or droplets of water appear on the shelves). The DAC Dynamic Refrigeration system improves the performance of the fridge compartment as can be seen by: · Faster cooling · A more uniform temperature distribution NOTE: When the DAC is operating on, cold production is heightened, so the refrigerator temperature control must be set to to avoid excessive cold. D338 Vegetable Drawer The drawer is suitable for storing fruit and vegetables. There is a separator inside the drawer that can be placed in different positions to allow for the subdivision best suited to personal needs. The drawer incorporates a device with slits (adjustable by means of a sliding lever), which makes it possible to regulate the temperature in the vegetable drawer(s). Close the slots to obtain a warmer temperature and greater humidity. ON) to obtain a cooler temperature and less humidity. ON PR271 5 Freezer Compartment This freezer, is marked , and is suitable for freezing fresh foodstuffs and keeping food for long periods. · Use lukewarm water and neutral soap or bicarbonate of soda for cleaning the interior and the exterior of the appliance. Never use detergents nor abrasive powders. · Clean the black grill on the read of the appliance (condeser), motor and the upper and downer ventilation slots with a brush or vacuum cleaner. This way the performance of the appliance will improve and energy consumption reduced. · Clean the water container above the motor. · Extract the base pulling it outwards in order to permit its cleaning. Defrosting of the freezer The inner walls of the freezer become gradually covered with a layer of frost keeping in mind not to open the door frequently and keeping the food wrapped up in closed bags. Whenever the thickness of ice reaches 5 mm. Remove all food staffand place it in the coolest possible place. Never pull up the sticked ice, you must wait untill it is melted, when the ice is soft you can remove it by helping yourself with a plastic ice-scraper, never use sharp objects, or heating households because the appliance could be seriusly damaged. Once removed the ice clean and dry the inside with a soft piece of cloth. You can plug it in again. Idle periods During periods when the appliance is not in use take the following precautions: · Unplug the appliance. [. . . ] · The appropiate «Temperature Regulator» is in position «0». · The door has been opened frecuently. · Inadequate position of «Temperature Regulator». · Food has been introduced recently in large quantities. [. . . ]