User manual ZANUSSI ZF4SILS

[. . . ] - - - - - - - - - - - - - - - - - - - - 25 Technical data- - - - - - - - - - - - - - - - - - - - - 29 Consumption values - - - - - - - - - - - - - - - - 30 Installation instruction - - - - - - - - - - - - - - - 31 Environmental concerns - - - - - - - - - - - - - 35 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, cleaning and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] To interrupt a programme which is running, depress the button 6 : the corresponding green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press the same button again. If an incorrect option is selected, the red pilot light of the button 6 flashes 3 times and the message Err is displayed for a few seconds. Altering an option or a running programme It is possible to change some options before the programme carries it out. Before you make any change, you must pause the washer-dryer by pressing the button 6 . Changing a running programme is possible only by resetting it. Turn the programme selector dial to «Off» and then to the new programme position. Start the new programme by depressing the button 6 again. The washing water in the tub will not be emptied out. Interrupting a programme Press the button 6 to interrupt a programme which is running, the corresponding light starts to flash. Press the same button again to restart the programme. For Synthetics you can select a drying time from 10 minutes to 130 minutes (2. 10). Every time you press the button the time increases by 5 mins. The drying time will automatically increase by up to 2 minutes. Press the button 6 to start the programme. After the programme has started, the time remaining is updated every minute. At the end of the programme, the buzzer sounds. Three flashing zeros «0. 00» will appear on the display. At this point, begins an «anti-crease phase», which lasts about 10 minutes. The door is locked and can be opened only at the end of this phase. If you wish to open the door before the anti-crease phase or to interrupt it, press any key or turn the programme selector dial to any programme position (except «Off»). The door can be opened immediately or in a few minutes depending on the model. [. . . ] Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance's rating plate. Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used. [. . . ]