User manual ZANUSSI ZF50/2

[. . . ] - - - - - - - - - - - - - - - - - - - - 20 Technical data- - - - - - - - - - - - - - - - - - - - - 23 Consumption values - - - - - - - - - - - - - - - - 23 Installation instruction - - - - - - - - - - - - - - - 24 Environmental concerns - - - - - - - - - - - - - 27 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] The Delay Start cannot be selected with «Drain» programme. Start the programme by pressing button 5 To start the selected programme, press this button; the corresponding green pilot light stops blinking. The pilot light 7. 1 is on to indicate that the appliance starts operating. The pilot light 7. 2 is on to indicate the door is locked. If you have chosen a delayed start, the machine will begin the countdown. Altering an option or a running programme It is possible to change some options before the programme carries it out. Before you make any change, you must pause the washing machine by pressing button 5. Changing a running programme is possible only by resetting it. Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by depressing button 5 again. The washing water in the tub will not empty out. Interrupting a programme Depress the button 5 to interrupt a programme which is running, the corresponding light starts blinking. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: The drum should be empty of laundry. Select the hottest cotton wash programme. Use a normal measure of detergent, must be a powder with biological properties. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. [. . . ] the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back side of the appliance. The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. 25 Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door and in the chapter «Technical Data». [. . . ]