User manual ZANUSSI ZF711W

[. . . ] FREEZER ZF711W INSTRUCTION BOOKLET 818 15 02--03/3 Important Safety Instructions GB These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. It will come in handy if you later sell the cabinet or give it to somebody else. Prior to Installation · Check the appliance for transport damage. [. . . ] Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. When moving the cabinet, lift it by the front edge to avoid scratching the floor. To Change the Light Bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. To replace the lamp in the chiller compartment (only cabinets with two doors), first unscrew the lamp grille with a screwdriver. Use a bulb of the same type, E14 socket, maximum rating of 25 W. 8 Zanussi 818 15 02--03/3 Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e. g. The frozen products can also be packed closely together and be kept in a cold location, e. g. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. Take out the drain spout and place it in the bottom freezer drawer where water can collect. Loosen the ventilation grille to enable the bowl to fit under the drain spout. Carefully scrape off the ice when it starts to thaw. Do not use sharp objects as these may damage the interior. When all the ice has melted, clean and wipe the cabinet dry, then push the drain spout back in place. Switch on the cabinet and replace the frozen foodstuff. Never use a hair dryer or other heating appliances to speed up defrosting. Excessive heat may damage the plastic interior, and humidity could enter the electric appliance making it live. When the appliance is not in use Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. Something Not Working Symptom The temperature is too high inside the freezer. Before contacting your local Service Force Centre check the following points: Solution Set a lower temperature. Make sure that the door is completely closed and that the rubber door seal is complete and clean. If warm food products have been put inside the freezer, wait for a couple of hours and then check the temperature again. Distribute the food products to allow cold air to circulate around them. [. . . ] * See on the rating plate on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification. a) b) 50mm 14 Zanussi 818 15 02--03/3 Climate classification SN N ST T for an ambient temperature of +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the baskets can be removed. connected to the terminal marked with the letter "E" or by the earth symbol yellow. or coloured green and Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ]