User manual ZANUSSI ZFC16/12

[. . . ] Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. If the appliance has been transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. [. . . ] Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the symbol are recyclable. Use The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Frozen food must not be re-frozen once it has been thawed out. Manufacturers' storage recommendations should be strictly adhered to. The inner lining of the appliance consists of channels through which the refrigerant passes. If 35 CONTENTS Installation Positioning Cleaning the interior Door reversibility 37 37 38 39 GB Aligning the refrigerator top with the other kitchen units Building the appliance in under a worktop Electrical connection 39 40 40 Technical specification Use Operation - temperature regulation Storing chilled foods Movable wire shelves Positioning the door shelves Ice cube production Defrosting 40 41 41 41 42 42 42 42 Maintenance Periodic cleaning Periods of non-use The light bulb 43 43 43 43 Troubleshooting 43 36 INSTALLATION If this model, equipped with a magnetic door lock, replaces an old appliance with a catch, ensure that the latter cannot be used before discarding it to prevent children being trapped inside. GB Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). Important For the appliance to function properly, an opening of at least 137 cm2 (Fig. A minimum clearance must also be provided between the condenser and the wall, as shown in the Fig. 4 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. 40 GB USE Operation - temperature regulation Turn the thermostat dial clockwise to the required position (beyond the «O» position); the intermediate setting is generally the most suitable. The temperature is automatically regulated; it can be increased by turning the dial towards the lower numbers and vice versa. When selecting the correct position, remember that the internal temperature depends on the following factors: ­ ambient temperature; ­ how often the door is opened; ­ the amount of food stored; ­ where the appliance is installed. To switch off, turn the dial until it coincides with the «O» symbol. GB Storing chilled foods The refrigerator compartment is suitable for chilling food and drinks. For best results, it is important to follow the rules below: do not put hot food or evaporating liquids in the refrigerator; cover or wrap all foods (especially spicy or strong-smelling foods); do not cover the shelves with paper, card or protective plastic sheeting which would prevent air from circulating through the grilles. We also recommend the following: cooked foods, cold dishes, jelly, etc. : should be well covered and may be placed on any shelf in the refrigerator; fruit and vegetables: should be washed and then placed in the salad box at the bottom of the refrigerator; butter and cheese: should be placed in suitable containers or wrapped in aluminium foil or plastic film to avoid drying out; milk in bottles: should be well capped and placed in the door compartment; raw meat (beef, pork, lamb, poultry): should be wrapped in plastic bags and placed in the special meat box or on the top shelf immediately below the evaporator. [. . . ] To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required. Fig. 6 Ice cube production D057 The refrigerator is equipped with one or more ice cube trays, which should be filled with drinking water and placed in the special compartment. Do not use metal implements to detach the trays. Defrosting During normal operation, the evaporator in the refrigerator compartment will gradually become covered with frost. This frost is a thermal insulator which inhibits cooling and must therefore be removed, otherwise there will be a significant reduction in cooling efficiency and an increase in electricity consumption. [. . . ]