User manual ZANUSSI ZFC22/10

[. . . ] Our Zanussi Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. 10 595 Closed door 600 43 Appliance height: 1380 mm 600 D223 Open door 1180 643 D224 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. [. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Ice lollies can cause frost burns if consumed straight from the appliance. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials; it must nevertheless be disposed of in a proper manner, in accordance with regulations for protection of the environment. 11 INSTALLATION If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Power connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. Remove the pivot and the washer (A+B-Fig. 3) from the upper hinge (C), then mount these on the opposite side. 3 4 3 D173 Re-assemble the door. 2) on the opposite side, using the screws previously removed. To do this, press it in the direction of the arrow. Insert the plug (G), which is supplied with the appliance, into the hole left free on the opposite side. Re-assemble the ventilation grille. 2 D164 5 1 Warning After having reversed the opening direction of the door, check that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. 13 USE Operation - Temperature adjustment Turn the thermostat knob clockwise beyond position «O» to the required setting. A medium setting is generally the most suitable. [. . . ] If this occurs readjust the knob so as to increase the temperature. Furthermore, make sure that: the frozen food to be stored has been kept at the proper temperature in the shop; transport of frozen food from the shop to the evaporator compartment is carried out in a brief time; do not exceed the storage time indicated on packages by the food manufacturer. After an idle period it is necessary to let the appliance run for at least two hours with the thermostat knob set on the coldest setting before placing any frozen food in this compartment. If no frozen food is stored in the evaporator, it is advisable to adjust the conveyor so as to reduce the temperature in the refrigerator compartment thus reducing energy consumption and improving food refrigeration performance. [. . . ]